User manual HOOVER D824-1

[. . . ] 15) A = casserole moyenne B = casserole grande C = poêle D = couvercles E = soupières, plats F = couverts G = plats à rôtis Le rangement rationnel et correct de la vaisselle est la condition essentielle pour obtenir un excellent lavage. This dishwasher is equipped with an anti-overflow safety device which works even when power is switched off, and closes off the water flow if, due to a possible malfunction, it exceeds the normal level. This activates a natural drying process, as with a normal draining board, simply by leaving the door ajar at the end of the cycle to enable the natural circulation of the water. The button permits an energy saving of more than 20% and shortens the cycle. [. . . ] In this case remove the working top of the dishwasher by unscrewing the screws under the rear edge of the top (fig. The height will then be reduced to 82 cm, as scheduled by the International Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top (fig. In the table below are listed different degrees of water hardness with the corresponding setting for the softener unit. The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. The standpipe must not be less than 40 cm above floor level and it must have an internal diameter of at least 4 cm. If necessary the outlet hose can be extended up to 2, 6 m, provided that it is kept at a maximum height of 85 cm above floor level. The hose can be hooked over the side of the sink (it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation) (fig. When installing the appliance under a worktop the hose pipe clamp must be attached to the wall in the highest possible position under the worktop (fig. Put your hand into the recess and push upwards. If the machine comes open while it is working, an electrical safety device automatically switches everything off. For the machine to work properly, the door should not be opened while it is in operation. - *The water softener unit is set in the factory at level 2, as this is suitable for the majority of users. If your water is at level 0, you need not use any regenerating salt, nor need you make any adjustment, as your water is soft. According to the degree of hardness of your water, regulate the softener unit in the following way: - remove the lower rack. Unscrew and remove the cap from the salt dispenser located in the bottom of the tub (Fig. 25) The cutlery basket is made with two detachable parts which will enable various loading options. The two parts can be detached by sliding the left section away from the right section. To load dishes For good washing results it is important to remove any remains from the dishes (bones, tooth picks, the remains of meat and vegetables) to avoid blocking the filters, water outlet and washing arm nozzles and, as a result, reduce washing efficiency. Try not to rinse the dishes before loading them into the dishwasher. If saucepans and oven dishes are particularly encrusted with the remains of burnt or roast food, it is advisable to leave them to soak before washing. Using the upper basket The upper basket is provided with mobile racks hooked to the sides of the basket which can be regulated in two positions: upright and lowered. In the lowered position the racks may be used for tea and coffee cups, kitchen knives and ladles. [. . . ] To reassemble it repeat the same operation, but turn it anticlockwise. The lower rotor arm can be removed simply by pulling it upwards (fig. Wash the rotor arms under a jet of water to clear any blockage in the spray heads. When you have finished, refit the rotor arms in the same position, remembering to locate the upper one on the stop and to screw it fully home. [. . . ]