User manual HOOVER ECOBRUSH

[. . . ] Pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items. Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours as this may cause risk of fire / explosion. Run over the supply cord when using your cleaner or remove the plug by pulling on the supply cord. Stand on or wrap the power cord around arms or legs when using the cleaner. [. . . ] To avoid a safety hazard, an authorised Hoover service engineer must replace the supply cord. When the dust reaches the max level indicator in the container, empty the dust container. IMPORTANT: To maintain optimum performance do not allow the dust to sit higher than the max level. Extract power cord and plug it into the power supply. Do not pull the cord beyond the red marker. Adjust the telescopic tube* to the desired height by moving the telescopic tube adjuster* up and raise or lower the hose handle to the most comfortable cleaning position. [7] Hard Floor ­ Brushes are lowered to protect the floor. Adjust the power level by further sliding the On-Off / variable power control* slider on cleaner mainbody. Switch off at the end of use by sliding the On-Off control to the OFF position. Unplug and press the carry handle/cord rewind button to wind the power cord back into the cleaner. Remove excess water from the exhaust filter and leave to dry fully before re-using. Refit the exhaust filter to grid once fully dry and refit the exhaust grid. IMPORTANT: Do not use the product without the exhaust filter fitted. Check if there is any other blockage in the system - Use a rod or pole to remove any blockage from the extension tube or flexible hose. Safety Although safety certification of electrical appliances is not required by law in the UK, Hoover believe that independent approval is the best way of demonstrating safety in design and manufacture. The British Electrotechnical Approvals Board (BEAB), the independent UK national authority for the safety of domestic electrical appliances, ensures that European safety standards are met and maintained throughout the production life of an appliance. All appliances that pass the requirements are permitted to carry the BEAB mark of safety. quality BSI ISO 9001 Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001. If the cleaner is used for a significant period of time when dust container is full, filters are dirty and with a blockage in the system, a thermal cut out will switch the cleaner off to prevent overheating. [. . . ] If the cleaner is used for a significant period of time when dust container is full, filters are dirty and with a blockage in the system, a thermal cut out will switch the cleaner off to prevent overheating. If this should happen, switch the cleaner off, unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset. Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. [. . . ]