User manual HOOVER FH50240

[. . . ] Please enter the complete model and Manufacturing Code in the spaces provided. CODE Hint: Attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER® product. Be sure to register your product online at Hoover. [. . . ] Continue to squeeze trigger and slowly pull cleaner back toward you (second wet stroke). 2a Squeeze trigger to apply cleaning solution and slowly push cleaner forward (equals one wet stroke). the cleaner washes on the forward stroke. Continue to squeeze trigger and slowly pull cleaner back toward you (second wet stroke). the cleaner rinses the carpet on the backward pass. The Dirty Water Tank lid (Pass over the same area a minimum of 4 times = 2 while squeezing the trigger and 2 without). Keep nozzle flat on floor for both forward and reverse strokes. 3 If you would like to rinse the carpet with water only, set Wash/Rinse Setting switch to RINSE. In this setting, rinsing will be done on both forward and reverse strokes. For best cleaning results and to aid in faster drying of carpet, end with more dry strokes. (Continue using dry strokes until little water is visible passing through the Dirty Water Tank lid. ) Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic shut-off", Fig. When finished cleaning, follow "After Cleaning" instructions on page 12. To assure proper rinsing, it is important to keep the cleaner on the same path backward as forward. Release trigger and slowly push cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull cleaner back toward you without squeezing trigger (dry stroke). Continue using dry strokes until little water is visible passing through To avoid saturating carpet, do not use more than 4 wet strokes over one area. Actual model may vary from images shown. (Available on select models only) The Clean Surge® button can be used to dispense extra solution when cleaning particularly soiled areas of carpet or spots. To use, press Clean Surge® button while squeezing solution trigger. Your HOOVER® carpet cleaner may also be used to pick up small liquid spills (one gallon or less, never to exceed 1/8" in depth). Unplug cleaner from electrical outlet and remove squeegee from nozzle. [. . . ] Do not send your vacuum to Hoover®, Inc. If you need further assistance: To speak with a customer service representative call 1-800-944-9200; Mon-Fri 8am-7pm EST. Always identify your vacuum by the complete model number when requesting information or ordering parts. To reduce the risk of fire and electric shock due to internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use with the appliance as noted below. [. . . ]