User manual HOOVER FL700 FLOORMATE

[. . . ] 48006478 1 4 a b 5 6 7 8 17 18 19 20 a b c d e c f a b a 9 10 11 12 21 22 d 23 24 h d e f g i g 13 14 15 16 25 c 26 d 27 28 h GB IMPORTANT SAFETY REMINDERS This cleaner should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. use only attachments recommended or supplied by Hoover. When using cleaning tools ensure to always steady the product with your other hand. [. . . ] [5] Cleaning Floors Recommended cleaning sequence: VACUUM: Vacuum to remove loose dirt, hair and debris. The brushes will provide light agitation to help loosen dirt. DRY: Pickup reduces drying time of the floor surface. [1D] Fill Clean Water Solution Tank with either floor cleaning detergent and water. turn Mode selector dial to WASH position. [1D] Dry hands and plug cleaner into a properly grounded outlet. Step on handle release pedal and lower handle to operating position. Slowly move cleaner forward and backward over area to be cleaned. The cleaner’s suction will pick up the dirty solution throughout cleaning. Raise upper handle to upright position until it locks in place. To greatly enhance drying of the floor surface, release trigger and turn Mode selector dial to the DRY position. [1D] Continue to move cleaner over the area to pick up the dirty solution. To continue cleaning another area, turn Mode selector dial to WASH position. Empty Dirty Water Tank or clean the filter when the motor sound becomes higher in pitch and there is a loss of suction (see “Automatic shut-off” section). cleaning the Filters The tank lid contains a washable , reusable filter. Clean this filter when suction is low or reduced. Turn cleaner off and disconnect from electrical outlet. Remove loose debris from filter by tapping the filter or gently brushing using your hand. The filter may also be rinsed for additional cleaning. Press down firmly until snapped in place. Dry or loose debris will also collect on the filter screen located in the tank lid. To remove debris from screen, remove the pleated filter from the lid. [. . . ] [5] TROUBLESHOOTING Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. PROBLEM Cleaner won’t run POSSIBLE CAUSE Power cord not firmly plugged in. blown fuse or tripped breaker SOLUTION Plug unit in firmly Check fuse or breaker in home. Replace Clean washable filter Empty the dirty water tank Make sure tanks are locked in place. [. . . ]