User manual HOOVER FLOORMATE PLUS FL700 011

[. . . ] 48006478 1 4 a b 5 6 7 8 17 18 19 20 a b c d e c f a b a 9 10 11 12 21 22 d 23 24 h d e f g i g 13 14 15 16 25 c 26 d 27 28 h GB IMPORTANT SAFETY REMINDERS This cleaner should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. use only attachments recommended or supplied by Hoover. When using cleaning tools ensure to always steady the product with your other hand. [. . . ] turn Mode selector dial to WASH position. [1D] Dry hands and plug cleaner into a properly grounded outlet. Step on handle release pedal and lower handle to operating position. Slowly move cleaner forward and backward over area to be cleaned. The cleaner’s suction will pick up the dirty solution throughout cleaning. Raise upper handle to upright position until it locks in place. To greatly enhance drying of the floor surface, release trigger and turn Mode selector dial to the DRY position. [1D] Continue to move cleaner over the area to pick up the dirty solution. To continue cleaning another area, turn Mode selector dial to WASH position. Empty Dirty Water Tank or clean the filter when the motor sound becomes higher in pitch and there is a loss of suction (see “Automatic shut-off” section). cleaning the Filters The tank lid contains a washable , reusable filter. Clean this filter when suction is low or reduced. Turn cleaner off and disconnect from electrical outlet. Remove loose debris from filter by tapping the filter or gently brushing using your hand. The filter may also be rinsed for additional cleaning. Press down firmly until snapped in place. Dry or loose debris will also collect on the filter screen located in the tank lid. To remove debris from screen, remove the pleated filter from the lid. The filter screen may also be cleaned by rinsing it under running water. Replace lid onto Dirty Water Tank, pressing down firmly until snapped in place. To replace Dirty Water Tank, place bottom of tank behind ledge (d) and push tank straight into cleaner body until it is locked in place. Picking up spills Your cleaner may also be used to pick up small liquid spills (1L or less, never to exceed 1/4 inch in depth) on non-carpeted floors. [. . . ] use recommended detergents to reduce foaming. Make sure clean water solution tank is installed properly. Make sure Filter and Filter lid are properly positioned. If the brushes continue to stall and the breaker trips again, clean the brushes to remove debris. [. . . ]