User manual HOOVER H1.M

[. . . ] Ensure that the mains supply is earthed, and if it is not, seek assistance from a qualified person. D) Do not touch the appliance when hands or feet are wet or damp. Do not use the appliance with bare feet. E) The use of adapters, multiple connectors and/or extensions is not recommended. Note: water temperature can reach 90°C during the wash cycle. F) Check there is no water left in the drum before opening the door. [. . . ] Liquid detergents, particularly suitable for grease stains, such as greasy skin marks, cosmetics and oil. These detergents are not suitable for washing stained laundry, as they do not contain bleach. Biological detergents, not all the products available give a really thorough wash. - Additional laundry aids Water softener, means less detergent can be used where water hardness is classed as hard to very hard. Prewash substances, for the programmed treatment of stains prior to the main wash. Using them means the subsequent wash can be at a low temperature or with bleach-free detergents. Fabric softener, prevents static build-up in synthetic fabrics and softens fabrics. If you own a tumble dryer, clothes are softened even without the use of a fabric softener. Do not put solvents in the washing machine!Keep detergents and other laundry products out of children's reach. Before pouring in the detergent check that there are no foreign bodies in the detergent drawer. Dosage details are usually shown on the detergent packaging. Follow those instructions. 18 Dosages Only use detergents which are suitable for use in a washing machine. Close the porthole again, ensuring that no items of laundry are obstructing the lock. Putting detergent in machine D) Open the drawer, choose the detergent and put in the correct amount, according to the manufacturer's instructions and the advice on page 18. Add any other laundry aids (see page 18). Close the drawer again. Selecting the wash programme Refer to the programme guide or the programme descriptions on the machine to select the most suitable programme. Turning the selector knob, the required programme is activated. Wait that a "SPIN" indicator light will go on. Press additional function buttons (if required). Check that the tap is turned on and that the discharge hose is positioned correctly. Press the "Start/Pause" button. When the "Start/Pause" button is pressed the machine sets the working sequence in motion. The programme carries out with the programme selector stationary on the selected programme till cycle ends. [. . . ] Britain and Northern Ireland only, and is an addition to your statutory rights. After Sales Service If, having investigated the possible malfunctions on the chart on the previous page, you believe the appliance is not working correctly, please call our After Sales Service dept. on telephone number: Gias Service - Tel: 08705 400 600 (Eire 018301 666) 26 Support Service Fig. load of dry laundry Water pressure SE 147 7 kg 0, 05 ÷ 0, 8 MPa SE 148 8 kg 0, 05 ÷ 0, 8 MPa Width Depth Height Measurements 60 cm 54 cm 85 cm 60 cm 54 cm 85 cm NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above. Appliance complies with European Directives 73/23/EEC and 89/336/EEC, replaced by 2006/95/EC and 2004/108/EC, and subsequent amendments. 27 SETTING UP + INSTALLATION 1 Remove the polystyrene base and place the machine near its permanent position (diagram 1). Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2). [. . . ]