User manual HOOVER H1 PET

[. . . ] One Touch is all it takes to meet your cleaning needs. One Touch switches the cleaner from carpet to hard floor cleaning. One Touch and the cleaning tool springs free, ready to reach over a full flight of 13 stairs. One Touch and you can empty the dust container quickly and hygienically. [. . . ] Rotate hand grip with your fingers to open fully the dust container and release the remaining debris (13b). The pre-motor filter and the Antibacterial foam filter are located beneath the pre-motor filter cover above the dust container. the dust screen is within the dust container. REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. 14 Pre-motor filter and Antibacterial foam filter Rotate the pre-motor filter cover anticlockwise (14a). The pre-motor filter and the Antibacterial foam filter are attached under the filter cover (14b). Using the tab provided remove the foam filter and wash under hand warm water. Remove pre-motor filter from the cover and rinse the inner side of the filter under hand warm water (14c). Allow to air dry thoroughly before refitting. refit pre-motor filter ensuring the thicker seal end is pressed into filter cover. REMEMBER ­ Clean these filters after every 5 dust container empties, or if there is a drop in performance. Lift out the pre-motor screen using the integral handle (15a). Use the dusting brush to remove any dust from the screen (15b). We recommend cleaning the screen after every 5 bin empties, or if there is a drop in performance. 16 Hepa Anti odour filter The One Pet is fitted with a HEPA Anti Odour exhaust filter to retain finest dust particles and unpleasant odours. After 12 months you may wish to replace the exhaust filter with a new one. This part can be ordered through the GIAS Service Division at 01204 - 556111 (Part no. The HEPA Anti Odour filter requires little or no maintenance and should only need checking if there is a drop in performance. to access the HEPA Anti Odour filter , remove the dust container from the cleaner (16a). Press the filter release button to release the exhaust filter (16b and 16c). REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. Use a blunt rod to remove any obstruction. [. . . ] During year 1 HOOVER engineers will replace or repair all defective parts free of charge, except for parts subject to fair wear and tear such as belts, brushes and bags. To qualify for benefits under guarantee, you must be able to provide proof of purchase and the appliance must have been supplied, maintained and used in accordance with HOOVER instructions. exclusions Consequential losses and accidental damage to the product. Any faults which occur due to bad installation or misuse. [. . . ]