User manual HOOVER H130E

[. . . ] Keep all documentation in a safe place for future reference or for any future owners. Check that no damage has occurred to the machine during transit. If it has, call for service by GIAS. Delivery information Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Energy label Call 08705 400 600 If the appliance is not running properly or breaks down, switch it off, disconnect the plug from the socket and do not tamper with the appliance. Consult GIAS Service for possible repair. Call 08705 400 600 Failure to comply with the above can compromise the safety of the appliance. You may be charged for a service call if a problem with your machine is caused by misuse. 3 40002267. qxd 26/11/2004 12:34 Page 4 Unpacking the product 1. [. . . ] The plug should be accessible for disconnection after the appliance has been installed. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH Do not plug the machine in and switch it on at the mains until the installation is completed. You may be charged for a service call if a problem with your machine is caused by incorrect installation. CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments. Adjusting the feet Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adjust the four feet to ensure the machine is firm and level. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the Hoover spares service. It must be installed by a competent person. Call 01204 556111 7 40002267. qxd 26/11/2004 12:34 Page 8 Ventilation For your safety, this dryer must be correctly installed. If there is any doubt about installation, call the national GIAS Service number for advice. Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. Check the fluff filter after use, and clean, if necessary. The inlet and outlets should be kept free from obstructions. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. There should be a gap of at least 12mm between the machine and any obstructions. Refit the condenser ensuring it is in the correct way (as indicated by the arrow) and pushed firmly into place. Lock the two levers by turning them clockwise. Refit the kickplate. 5. 6. 14 40002267. qxd 26/11/2004 12:36 Page 15 Operation Refer to the Drying guide table or the fabric labels to select the most suitable programme. Open the door and load the drum with laundry. Ensure that garments do not hinder closure of the door. If drying delicate items press the `ACRYLICS/SYNTHETICS' button to reduce the heat level. Press again on completion, to select high temperature. HIGH heat setting LOW heat setting Turn the `DRYING TIME' Selector until the required drying time aligns with the dial. The Fast Iron programme provides a conditioning and anti-crease function. The dryer will heat the load for 8 minutes followed by a 2 minute cool down period and is especially good for garments which may have been left for some time prior to ironing, in a linen basket for example. Garments may also become stiffened when dried outside on a washing line or inside on radiators. [. . . ] Is the dryer switched on, both at the mains supply and at the machine?Has the drying time or the programme been selected?Has the machine been switched on again after opening the door?Has the dryer stopped operating because the water tray is full and needs emptying? The dryer is noisy. . . Switch off the dryer and contact the GIAS service number 08705 400 600 for advice. The Filter Care Indicator is on. . . Does the filter need cleaning? [. . . ]