User manual HOOVER HARD FLOOR CLEANER FH40010

[. . . ] For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST before returning this product to the store. Please enter the complete model and Manufacturing Code in the spaces provided. Code Hint: Attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER® product. [. . . ] Replace lid onto Dirty Water Tank, pressing down firmly until snapped in place. 20 To replace Dirty Water Tank, place bottom of tank behind ledge (D) and push tank straight into cleaner body until it is locked in place. VACUUM: Vacuum to remove loose dirt, hair and debris. 1 For dry debris pickup, turn the dial to the VACUUM position. In this position, the brushes will not rotate and are raised off the floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use FloorMateTM SpinScrub® cleaner to wet clean sealed wood floors if any of these conditions exist. set Mode selector dial to VACUUM position and vacuum floor. Turn cleaner off and disconnect from electrical outlet. Fill Clean Water Solution Tank with either Floor to Floor Cleaning Concentrate or Grout Cleaner, depending upon the type of floor being cleaned, and water (see Figs. Do not use solvent based cleaning concentrates in your cleaner. Do not use any type of wax in your cleaner. turn Mode selector dial to WASH position. Dry hands and plug cleaner into a properly grounded outlet. Step on handle release pedal and lower handle to operating position. Slowly move cleaner forward and backward over area to be cleaned. The cleaner's suction will pick up the dirty solution throughout cleaning. To greatly enhance drying of the floor surface, release trigger and turn Mode selector dial to the DRY position. Continue to move cleaner over the area to pick up the dirty solution. To continue cleaning another area, turn Mode selector dial to WASH position. Empty Dirty Water Tank or clean the filter when the motor sound becomes higher in pitch and there is a loss of suction (see "Automatic shut-off" section). [. . . ] The motor is equipped with bearings which contain sufficient lubrication for the life of the motor. If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. Any other servicing should be done by an authorized service representative. To reduce risk of personal injury - unplug cleaner before servicing. [. . . ]