User manual HOOVER HARD FLOOR POLISHER

[. . . ] ⷠClose supervision is necessary when any appliance is used by or near children. Do not allow cleaner to be used as a toy or to run unattended at any time. ⷠKeep hair, loose clothing, fingers, feet and all parts of body away from openings and moving parts. ⷠDo not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. [. . . ] Your HOOVER FloorMateTM SpinScrubTM 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood. It is not intended for use on carpet or rugs. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use FloorMateTM SpinScrubTM Cleaner to wet clean sealed wood floors if any of these conditions exist. For dry debris pickup, turn the dial to the 19 DRY VAC position. In this position, the brushes will not rotate and are raised off the floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position. The solution tank holds detergent and water that is to be dispersed onto the surface being cleaned. How to fill 21 A To remove tank, squeeze release button and pull tank 20 straight out. For hard surface floors such as vinyl, linoleum, laminate wood, polyurethane sealed wood or other wood floors that can normally be cleaned using water, use one cap (2 oz. Dry or loose debris will also collect on the filter screen located in the tank lid. To remove debris from screen, remove the pleated filter 31 from the lid. The filter screen may also be cleaned by rinsing it under running water. Replace lid onto recovery tank, pressing down firmly until snapped in place. 32 To replace recovery tank, place bottom of tank behind 32 ledge (E) and push tank straight into cleaner body until it is locked in place. How to clean Dry Vacuum to remove loose dirt, hair and debris. 33 For dry debris pickup, turn the dial to the DRY VAC position (A). In this position, the brushes will not rotate and are raised off the floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position (B). NOTE: Your HOOVER® FloorMateTM SpinScrubTM 800 cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. [. . . ] ⷠMake sure that nothing is pressing on the nozzle squeegee. ⷠDo not store cleaner on a wood surface unless cleaner is completely dry. I The two sections of the tool caddy snap together for assembly. 41 To store hose: Place the hose grip (C) into slot (D) on back of caddy. [. . . ]