User manual HOOVER HBP60

[. . . ] Connect it to a socket which conforms with current regulations. If you intend to connect it directly to the electric mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. [. . . ] For a further adjustment act on the screws J through the holes N (fig. The hood is fitted with a microswitch connected to the flap: with the flap pushed in, the motors switch off; with the flap pulled out, the function previously set will be reactivated. -- It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. Then fix the door to the front panel by means of the screws Q (fig. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. 2 on the side of the right cupboard, so that the side B matches the front part of the cupboard (disregard the thickness of the flap) and drill two holes 2, 5 mm diameter in the points B1 and B2 (fig. Then apply the same scheme on the side of the left cupboard, matching the side C with the front part of the cupboard (disregard the thickness of the flap) and drill two holes 2, 5 mm diameter in the points C1 and C2 (fig. Fix the hood to the cupboards by means of the screws R (fig. Replace the door, inserting it first in the upper then in the lower slides, turn the rear locking knobs P and then mount the metal filters, following in revers, the operations described under paragraph "Internal recycling version". Adjust the angle frame tightly to the wall, making use of the apposite screws M (fig. The angle frame has one long arm and one short arm, to be used in alternative depending on the depth of the cupboards. [. . . ] C) It is advisable to clean the grill whenever the filter is washed. D) Ensure that the grill is completely dry before refitting it. -- Before calling for technical assistance because the hood fails to light up, make sure the lamps are well mounted . [. . . ]