User manual HOOVER HDA 341

[. . . ] Together with the seal on the two Domino cook tops, the steel support will ensure that the top is watertight. The Domino cook tops are fixed to the work top using the kit of brackets provided. Using a gas cooker produces heat and humidity in the room in which it is installed. Ensure the room is well ventilated by keeping all the natural air vents open or by installing a kitchen hood with an outlet duct (Fig. [. . . ] Between the hob and any exhaust hood it must be a distance of 70 cm at least. Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated mains voltage and power available are suitable for its operation. The manufacturer will accept no liability for any personal injury or damage to property deriving from failure to comply with this requirement. For models without a plug, fit a standard plug capable of withstanding the specified load on the nameplate. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the terminal block cover again immediately. If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line conductors. Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1. This appliance, in the parts intended to come into contact with food, complies with the requirement of the Directive 89/109 EEC and the D. This appliance complies with the requirement of the European Directive 73/23/CEE and 89/336/CEE, replaced by 2006/95/CE e 204/108/CE and following modifications and also to the European directive No. Please monitor children in order to ensure that they are not playing with the appliance. This appliance must be used for the purpose it was designed for, i. Any other use is considered to be improper and therefore dangerous. The manufacturer will accept no liability for any damage caused by improper, incorrect or irrational use. If the burners are not used for several days, wait a few seconds before lighting them in order to release any air from the pipes. As the cook top burners are fitted with an automatic ignition, to light them simply press and turn the handle to the small star. the appliance uses a spark ignition generator. If the flame does not ignite within five seconds, turn the knob back to the 0 position and repeat the procedure. For models with a safety tap (which interrupt the gas flow should the flame accidentally go out) the burners are ignited as described above, but ensure the knob is pressed in for 5 to 6 seconds after the flame has ignited. After this time, which gives the safety device enough time to cut-in, the flame will be on permanently. ATTENTION: once the cook top has been cleaned, ensure that the burners are firmly in their seats and do not interfere with the igniter. [. . . ] WARNING: if the burner flame is extinguished accidentally, turn off the knob and leave it for at least one minute before trying to re-ignite it. Before cleaning or maintenance, the plug must be removed from the mains socket or the electricity switched off at the electric system mains switch. Before cleaning, wait for the appliance to cool, then wash the enamelled, painted or chrome-plated parts with warm water and soap or non-corrosive washing-up liquid. For the steel parts, use alcohol or any other suitable product on the market. [. . . ]