User manual HOOVER HDC 60E

[. . . ] WARNING Do not use the product if the fluff filter is not in position or is damaged; fluff could be ignited. WARNING Foam rubber materials can, under certain circumstances, when heated become ignited by spontaneous combustion. Always refer to the laundry care labels for directions on suitability for drying. wARNING Misuse of a tumble dryer may create a fire hazard. [. . . ] D) By drying level Sort into: iron dry, cupboard dry, etc. Woollens, silk, delicate fabrics, nylon stockings, delicate embroidery, fabrics with metallic decorations, garments with PVC or leather trimmings, training shoes, bulky items such as sleeping bags, etc. IMPORTANT: Do not dry articles which have been treated with a dry cleaning fluid or rubber clothes (danger of fire or explosion). Gently remove lint using a soft brush or your fingertips. Snap the filter together and push back into place. Filter Care Indicator ( ) Lights when the filter needs cleaning. If the laundry is not drying check that the filter is not clogged. Only put into the tumble dryer laundry which has been thoroughly wrung or spindried. the drier the laundry the shorter the drying time thus saving electricity. ALWAYS try to dry the maximum weight of laundry, this will save time and electricity. NEVER exceed the maximum weight, this will waste time and electricity. ALWAYS check that the filter is clean before every drying cycle as this aids efficiency. NEVER put dripping wet items into the tumble dryer, this may damage the appliance and waste time and efficiency. The water removed from the laundry during the drying cycle is collected in a container at the bottom of the dryer. Gently pull the bottom of the kickplate so that it unclips from the dryer (fig. The top section can then be unhinged allowing the kickplate to be completely removed. Pull firmly on the handgrip and slide the water container out of the dryer (fig. When full, the water container will weigh about 4 kg (fig. Refit the kickplate by engaging the hinges at the top and `snapping' the lower clips into place. IMPORTANT: Always switch off and remove the plug from the electricity supply before cleaning the condenser. Turn the two locking levers anticlockwise (fig. Gently remove any dust or fluff with a cloth, then wash the unit by holding it under a running tap (fig. [. . . ] If there is an interruption to the electricity supply the time delay will be lost and so will have to be re-set when the power is restored. To switch off the buzzer, which sounds at the end of each cycle, press the `ALARM OFF' ( ) button. Cool air is used for the last 10 minutes to reduce creasing and cool the load ready for handling. If the load is not removed from the dryer at the end of the drying cycle, a `creaseguard' function is activated. [. . . ]