User manual HOOVER HDPN 4S603PX

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in order to clean the machine of any deposits; 2. Turn off the water tap; Keep the inside of the machine clean; 7. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage 10) "Total care" PROGRAMME INDICATOR LIGHT When the Total Care programme is enabled, the corresponding indicator light comes on. The display keeps you constantly informed 11) "HALF LOAD" OPTION INDICATOR On the operation of the appliance. 1) TEMPERATURE DISPLAY Indicates the washing temperature of each programme selected. 2) PROGRAMME DISPLAY Indicates set wash programmes, provides information on set options, reports any faults and so on. Touching the display in the first few seconds after you have plugged in the appliance could interrupt its selfcalibration procedure, thus jeopardising the appliance's proper functioning. In this case, take out the plug and repeat the operation. 3) TIME REMAINING DISPLAY Indicates the wash time for each selected programme and provides the time remaining to the end of the programme. At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. 4) WATER SUPPLY CLOSED INDICATOR LIGHT Indicates any fault in the inflow of water between the tap and the dishwasher (see "TROUBLESHOOTING AND WARRANTY"). First time you switch on the appliance L When you have connected the appliance to the mains and switched it on via the Start/Reset button, "ENGLISH" will appear on the display. L The appliance is now in language setting mode. l Select the language desired by pressing The HALF LOAD and EXTRADRY buttons, then confirm your selection by pressing the "Start/Reset" button. L A "WELCOME" message will appear on the display for 5 seconds. From the settings menu, you can adapt various parameters to your washing needs. L Press the HALF LOAD and EXTRADRY buttons together for 5 seconds. The dishwasher must ALWAYS be off l Follow the steps detailed in the Before you start this procedure. [. . . ] This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that no water remains inside the appliance. Dishwasher does not fill with water Spray arms are not heard to rotate CAUSE Plug not connected to wall socket O/I button not pressed Door is open No electricity Filter is dirty Drain pipe is bent The drain pipe extension is not correctly connected The outlet connection on the wall is pointing downwards not upwards Position of the drain pipe is too low excessive amount of detergent Item prevents arms from rotating Filtering plate and filter very dirty Lift drain pipe to at least 40 cm above floor level Appliances without a display: one or more indicator lights flashing quickly 7. [. . . ]