User manual HOOVER HFT60 7-03

[. . . ] Select the suitable air duct and apply the flange C supplied, ensure to close the unused hole duct with tap D supplied if provided. In some models the rear hole duct is not easily accessible, even when the tap (if mounted) is removed, in this case remove the plastic piece E1 or E2 that is blocking the hole duct, by unwinding using pliers and cutter. check that the filter/ suction selector (inside the cooker hood) G is in the suction (A) position. [. . . ] Do not fix chimney flue to furniture or fly over shelves unless the chimney flue can be easily removed, in case maintenance is ever required. The cooker hood must be placed at a minimum distance of 60 cm from the cooking plane for electric cookers and 75cm for gas or mixed cookers. The cooker hood may be installed on the wall or on the base of a cabinet; if supplied, use the hole gauge H to drill the correct distance, otherwise lean the cooker hood on the wall or on the base of the cabinet and mark the holes with a pencil. And the two K screws in the upper drill holes, remove the grill and hook the cooker hood to the 2 screws, finally from the inside, insert the third screw L and lock them all in. Rectangular S1 or S2 or S3: to be replaced every 6 months Mounting (S1 or S2) : insert the rear side T and hook further to the front (U). Mounting (S3): Remove the cover W by rotating the O knobs to 90° , then close the cover. Bayonet mount position the filter in the middle of the motor protection grill covering ensuring that the reference to X1 or X2 or X3 on the carbon filter match the Y1 or Y2 references on the conveyor, then turn clockwise; in case of dismounting turn anticlockwise, if provided with a Z tape remember to gently lift first. Carbon Filter - it may be one of the following types: Replacing lightbulbs 40W - Unscrew the damaged light bulb and Replacing the hologen bulbs - Access the light compartment Replace with an incandescent oval light bulb with a maximum of 40W E14. Remove the grill in order to reach the light bulb area. Extract the lamp cover by levering it off with a small screwdriver or similar tool. Prior to touching the light bulbs ensure they are cooled down. Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. Close the lamp cover (it will snap shut). Wall mounting - Insert the wall screw anchors J in the drilled holes Cabinet fixing - Affix the cooker hood with the 4 M screws from Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. Use the highest speed for situations of high level vapour concentration in cooking. [. . . ] - Prior to any maintenance operation ensure that the cooker hood is disconnected from the electrical outlet. - The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]