User manual HOOVER HHI 694

[. . . ] 1) that temporarily fix the two parts of the lattice girder together. Adjust the extension of lattice girder "L", according to the following formula: L = h - (d+44cm) Where: L= lattice girder extension, h = distance between the ceiling and the support surfaces of the cooking device containers. D= distance between the lower park of the hood and the support surfaces of the cooking device containers. Fix the lattice girder with the 8 D screws (Fig. [. . . ] Remove the carbon filter holding frame and tighten internal screw R (Fig. 3) that adjusts the position of the commands box so that the keys extrude from the flue. Block the position tightening the lock nut on the screw. 5), placed between the bulbs, temporarily and fix filter holder mask U (Fig. Speed 1 LED Speed 2 LED and metal grease filter saturation LED (in this latter case, the LED will flash - See instructions on grease filter cleaning). Once the grease filters have been cleaned, press button 1 for about 3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. Speed 3 LED and active carbon filter saturation LED (in this latter case, the LED will flash - See instructions on active carbon filter replacement). Once you have replaced the charcoal filter, press button 1 for about 3 seconds until you hear the acoustic signal (beep). Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 will also start flashing, indicating that the active carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. Intensive speed LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. OFF lamp button ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Never use the hood without the grill mounted! [. . . ] Insert it into its housing and fix it turning the 2 plastic knobs. Prior to touching the light bulbs ensure they are cooled down. On the product, or on the documents The symbol accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]