User manual HOOVER HNC775T

[. . . ] 40003604. qxd 25/07/2005 15:35 Page 1 Instruction Book HNC775T Condenser Tumble Dryer ® 40003604. qxd 25/07/2005 15:35 Page 2 Contents Introduction . . 5 5 6 6 6 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Electrical requirements . 16 Cancelling and resetting the programme . 16 Cleaning and Routine Maintenance . [. . . ] Digital Display ­ The two digit display indicates the selected programme, the Start Delay and the Time to End of the programme 11 40003604. qxd 25/07/2005 15:36 Page 12 Door and Filter Opening the door Pull on handle to open the door. To restart the dryer, close the door and press the `Start/Reset' button. WARNING!When the tumble dryer is in use the drum and door may be VERY HOT. Filter IMPORTANT: To maintain the efficiency of the dryer check that the fluff filter is clean before each drying cycle. Gently remove lint using a soft brush or your fingertips. Snap the filter together and push back into place. Filter Care Indicator Lights when the filter needs cleaning. If the laundry is not drying check that the filter is not clogged. 12 40003604. qxd 25/07/2005 15:37 Page 13 Water Container The water removed from the laundry during the drying cycle is collected in a container at the bottom of the dryer. When the container is full the `EMPTY WATER' indicator on the control panel will light, and the container MUST be emptied. However, we recommend that the container is emptied after each drying cycle. NOTE: Very little water will collect during the first few cycles of a new machine as an internal reservoir is filled first. To remove the container 1. Gently pull out the tray until it is completely removed. When it is full the water container will weigh about 4kg. 2. Open the the lid located on the top of the container and empty the water out. Refit the lid and slide the water container back into position. PUSH FIRMLY INTO PLACE. NOTE: If you have the option of drainage near the dryer it is possible to use the discharge kit to provide a permanent drain for the water collected by the dryer. This will remove the need to empty the water tray. All the information for assembly of the kit is contained in the kit envelope. 13 40003604. qxd 25/07/2005 15:37 Page 14 Condenser To remove the condenser 1. Gently pull the bottom of the kickplate so that it unclips from the dryer. The top section can then be unhinged allowing the kickplate to be completely removed. 2. 3. Turn the two locking levers anti-clockwise and pull out the condenser. Pull out the condenser unit. 4. Gently remove any dust or fluff with a cloth, then wash the unit by holding it under a running tap turning it so that water flows between the plates, to remove any dust or fluff. Refit the condenser ensuring it is in the correct way (as indicated by the arrow) and pushed firmly into place. Lock the two levers by turning them clockwise. Refit the kickplate. 5. 6. 14 40003604. qxd 25/07/2005 15:37 Page 15 Selecting the Programme The Hoover Sensor Dry machine gives many options for drying the laundry to suit all circumstances. [. . . ] Does the water container need emptying? The dryer does not operate. . . The dryer is noisy. . . The Filter Care Indicator is on. . . 18 Empty Water Indicator is on. . . 40003604. qxd 25/07/2005 15:37 Page 19 Customer Service Note: If the supply cord on this appliance is damaged, it must be replaced by a special cord which is only available from GIAS Service or an authorised Hoover Dealer. Should there still be a problem with your dryer after completing all the recommended checks, please call the national GIAS Service number for advice. They may be able to assist you over the telephone or arrange for a suitable appointment for an engineer to call under the terms of your guarantee. However, a charge may be made if any of the following applies to your machine: Is found to be in working order. [. . . ]