User manual HOOVER HNL71663

[. . . ] 40004968. qxd 23/05/2007 13:38 Page 1 Instruction Book ® 40004968. qxd 23/05/2007 13:38 Page 2 Contents Introduction. 8 Connection of the machine to the drain . 32 2 40004968. qxd 23/05/2007 13:38 Page 3 Introduction Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. [. . . ] The amount of water is also increased during the rinse procedure so as to remove all traces of detergent from the fibres. This function has been specifically designed for people with delicate and sensitive skin, for whom even a very small amount of detergent can cause irritation or allergy. 18 40004968. qxd 23/05/2007 13:40 Page 19 You are advised to also use this function for children's clothing and for delicate fabrics in general, or when washing garments made of towelling, where the fibres tend to absorb a greater quantity of detergent. To ensure the best performance for your wash, this function is always activated on the Delicates and Woollens programmes. Delay Start This option is available to delay the start of the wash cycle by up to 9 hours. The selection of the time is completed by pressing the Delay Start button, the countdown display will indicate the time selected. When the correct delay is selected press the Start Pause button to start the cycle. Temperature The Temperature button allows the reduction in the wash temperature in each programme. Each time the button is pressed the temperature decreases until a minimum of 15°C (cold wash ) Note: The temperature must be adjusted before selecting Wash Time. Fast Iron This option is only available on the Synthetics, Acrylics, Woolmark and Silk programmes. Programme Synthetics Acrylics Fast Iron function The programme is completed by a short spin of very low speed. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Action required to complete the cycle To select a full spin cycle please turn the dial to the required spin programme. Press the Fast Iron button to continue with the programme. The machine will then pump out the water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the Fast Iron button and the machine will pump out the water and complete the cycle with a short spin cycle. Woolmark Silk Press the Fast Iron button and the machine will pump out the water to complete the cycle. The load will not be spun and will therefore be very wet. Spin Speed The spin cycle is very important to remove as much water as possible from the laundry without damaging the fabrics. You can adjust the spin speed of the machine to suit your needs. By pressing the Spin Speed button, it is possible to reduce the maximum spin speed, and if you wish, the spin cycle can be cancelled. To re-activate the spin cycle it is enough to press the button until the required spin speed is indicated. [. . . ] Remove the plug from the mains power supply socket. Carefully move the machine so the rear of the machine is accessible. Please follow the safety precautions which we recommend under the Safety Notes section of this manual. Unclip the drain hose from the rear panel of the machine and lower the hose into a bowl on the floor. [. . . ]