User manual HOOVER HNL842

[. . . ] 40001979Eng. qxd 21/09/2004 17:19 Page 1 Instruction Book Washing Machine ® 40001979Eng. qxd 21/09/2004 17:19 Page 2 English . 36 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Delivery information . 9 Connection of the machine to the drain . 13 The Dispenser Loading your washing machine. [. . . ] When the correct delay is selected press the Start Pause button to start the cycle. Extra Rinse (Extra Spülen) This option is available on the cottons programmes. The option increases the number of rinses to five (including the final conditioned rinse). This can help prevent skin irritation from detergent residue for people with particularly sensitive skin. Selecting the Extra Spülen button is also recommended when washing heavily soiled fabrics which need a lot of detergent, or when the wash load contains towelling fabrics that have a greater tendency to retain detergent. 20 40001979Eng. qxd 21/09/2004 17:20 Page 21 Fast Iron (Leichtbügeln) This option is only available on synthetics, acrylics, woolmark and silk programmes. Programme Synthetics (Synthetik) Fast Iron Function Programme is completed by a short, very low spin speed. Action to complete the cycle If a spin cycle is required please select the appropriate spin (see Programme Guide). Press the Leichtbügeln button to continue with the programme. The machine will then pump out the remaining water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the Leichtbügeln button and the machine will pump out the water and complete the cycle with a short spin cycle. The machine stops in the Acrylics (Feinwäsche) final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Woollens (Woolmark) The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Silk (Seide) Press the Leichtbügeln button and the machine will pump out the water to complete the cycle. The clothes load will not be spun and will therefore be very wet. 21 40001979Eng. qxd 21/09/2004 17:20 Page 22 Temperature Selector (Temperatur °C) The washing machine is equipped with a Temperatur °C selector knob to set the temperature you require. Bigger energy savings can be achieved by using the lower temperature settings around the dial between and 40°C. By selecting the position, the wash temperature is limited to the water inlet temperature, thus reducing energy consumption further. We recommend that the temperature shown on wash care garments should never be exceeded. In the case where the temperature has been accidentally set higher than that of the chosen programme, (see Programme Guide table), the machine will lower the temperature automatically to protect the fabrics. Spin Speed Selector (Schleudern) By adjusting the control knob it is possible to reduce the maximum spin speed of your selected programme to suit your needs and to help reduce any creasing of fabrics. Turn the Schleudern selector knob until the indicator aligns with the required spin speed. The maximum spin speed will vary depending on the specification of the machine. 22 40001979Eng. qxd 21/09/2004 17:20 Page 23 Automatic Features Automatic Variable Capacity (Half Load) The washing machine is fitted with a self adjusting water level system. This system enables the machine to use the optimum amount of water needed to wash and rinse the laundry in relation to the particular load. This results in a reduction of the water and electricity used without in any way compromising the washing and rinsing performance. The amount of water and electricity used will always be appropriate for the clothes load. The washing machine automatically ensures excellent washing results at minimum cost whilst respecting the environment. Out of Balance protection This model is fitted with an electronic sensor device that checks if the load is balanced correctly. If the load is slightly unbalanced the machine will re-balance it automatically to then carry out the normal spin. [. . . ] Has the Tür geschlossen light gone out?If not wait a further couple of minutes and the light will go out and you will be able to open the door. Has the programme finished but the door remains locked?The START and Vorwäsche light will flash intermittently indicating that the water supply has been interrupted during the wash cycle. [. . . ]