User manual HOOVER HOS556

[. . . ] Read the instructions carefully to make the most of your oven. We recommend you keep the instructions for installation and use for later reference, and before installing the oven, note its serial number below in case you need to get help from the after-sales service. When you have unpacked the oven, make sure that it has not been damaged in any way. If you have any doubts at all, do not use it: contact a professionally qualified person. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. PRELIMINARY CLEANING - clean the oven before using for the first time: . Wipe over external surfaces with a damp soft cloth. Wash all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. Ensure that the room is well ventilated while this is being done. Stopping the oven: this may be necessary if you have input an incorrect instruction. Child safety device: To lock the oven controls, select the child safety device. refer to the section entitled "Programming - The child safety device". The cooling fan: this protects the control panel and electronics from heat damage. It begins and then stops automatically even when the oven is switched off. Oven lighting: By turning to the light symbol, you can switch on the oven light when it is not in use. When the oven is in use, the light stays on during all of the oven functions and when the door is opened. CLOCK SETTING When the oven is connected to the electricity supply or after a long power cut, the clock must be re-set. 3-The hours will then flash, set with the central button by turning to the "-" or "+", confirm by pressing the central button. 4-Turn back the control to the STOP position, the new hour is set. LANGUAGE CHOICE The pre-set language setting on the display panel is in Italian, but it can be changed to Spanish or English. To change the language display, carry out the following procedure : 1- Turn the programme selector knob to "Light" symbol. Turn the button until the required language appears and confirm by pressing the same button. Turn the programme selector knob back to the STOP position. When the oven is on standby - only the time of day appears on the display. [. . . ] Turn the central button to indicate the required number of minutes, and confirm your choice by pressing the same button. Turn the central button to indicate the required number of hours, and confirm your choice by pressing the same button. NB : with a delayed start, the end of programme time will appear on the display with the "Cooking time" and "STOP" symbols, and only the function mode of the oven remains. For 15 seconds, an audible signal lets you know that the cycle has ended and the "Cooking time" and STOP symbols will flash. [. . . ]