User manual HOOVER HPD90

[. . . ] Securing the cooker to the wall Drill two holes in the wall approximately 70 cm above the lower edge of the sides of the cooker (as shown in fig. A position F, so that they are concealed by the cooker itself (see fig. Insert part R (rawlplug) into holes F and screw hook G into part R (fig. ) and dispose of them in accordance with local waste disposal laws. [. . . ] Functions Cooking time, cooking end time, manual position, clock, minutes counter, times to be set up to 23 hours 59 minutes. display 4-figures , 7-segments diplay for cooking times and time of day. Cooking time and manual function = saucepan symbol Automatic function = AUTO Minutes counter = bell symbol The symbols light up when the corresponding functions are selected. 4 Setting To set, press and release the desired function, and within 5 seconds set the time with and buttons. The + and - buttons increase or decrease the time at a speed depending on how long the button is pressed. Before cleaning the appliance, disconnect the gas general tap and unplug the appliance or disconnect power at the main circuit breaker of the electrical system. Do not clean the appliance surfaces when still hot. IMPORTANT Periodically check the external gas connection hole and replace it when it shows any sign of deterioration. Do not attempt to repair the gas hose under any cincumstances. ENAMELLED SURFACES Clean with a damp sponge using soap and water. Grease can be easily removed using hot water or a specific cleansing agent for enamelled surfaces. Do not leave any acid or alkaline substances (lemon juice, vinegar, salt, etc. In the UK, CORGI registered installers work to safe standards of practice. The cooker must also be installed in accordance with BS 6172: 1990. Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution. gas Connection Prior to installation , ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which can be found on the inside of the front appliance drawer . This appliance is not designed to be connected to a combustion products evacuation device. Particular attention should be given to the relevant requirements regarding ventilation. Connection to the cooker should be made with an approved appliance flexible connection to BS 669. Models for use with LPG should be fitted with a hose suitable for LPG and capable of withstanding 50mbar pressure. The length of hose chosen should be such that when the cooker is in situ, the hose does not touch the floor. [. . . ] Do always keep ventilation slots clear of obstructions. Do always turn off the electricity before cleaning or replacing an oven lamp. Do not allow children near the cooker when in use as all surfaces will become hot during and after cooking. Do not allow anyone to sit or stand on any part of the cooker. [. . . ]