User manual HOOVER HVG32

[. . . ] A = plates for inserting on the bottom of the cook top B = fixing bracket C = screw Important - The figure below shows how the seal must be attached all around the perimeter. Coupling two or more Domino cook tops Cut out the work top to allow for the flush mounting of two or more Domino cook tops. First of all, place the steel supporting element (E) provided in the package in position, then insert the cook top (G) as illustrated in the figure below. [. . . ] The cook top must be connected to the gas mains or canister in accordance with Standards UNI-CIG7129 and 7131, ensuring beforehand that it is regulated to suit the gas-supply. If it is not, follow the instructions in the "Adapting to different gas types" paragraph. If fed by a canister of liquid gas, use pressure regulators that comply with Standards UNI-CIG 7432. Important: for safe operation, suitable use of energy and longer equipment life, ensure that the feeding pressure is within the values shown in the table (Burner Technical Details page 6). These instructions are for authorised cook top installers in accordance with standards UNI-CIG-7131. Any procedure must be carried out with the appliance disconnected from the electricity mains. ATTENTION: the packaging contains two couplings, one cylindrical and one conical; choose the appropriate coupling according to the country of installation. Only use pipes that comply with Standards UNI-CIG 9891 and seals that comply with UNI-CIG 9264. These pipes must be installed so that, when fully extended, their length does not exceed 2000 mm. To facilitate installation and to prevent gas leaks, firstly attach the swivel coupling to the cook top and then to the gas mains pipe. Inverting this sequence may hamper the gas seal between the pipe and the cook top. Important: when installation is complete, check that all the couplings are completely sealed by using a soapy solution. Also ensure that the flexible pipe cannot come into contact with any moving part of the cook top (e. Drawer) and that it is not in a position where it could be damaged. In order to adapt a cook top to a gas other than the one it is set for, follow this sequence of instructions: remove the pan support and the burner unfasten the injectors (M) with a socket spanner and replace them with the injectors that have a diameter suited to the new gas type (see the "Burner Technical Details" table) after finishing this sequence, replace the old setting label with the new one provided for the new injectors. BURNER TECHNICAL DETAILS Burner Rated heat output kw Reduced heat output kw DE-AT reduced heat output kw Ø INJECTOR G30/G31 28. Turn on the burners by setting the tap in the minimum position and remove the knob (this can be done because it is simply pressed into place). Take a small screwdriver and turn the tap-regulating screw anticlockwise in order to increase the gas delivery and clockwise in order to decrease it, until a 3 or 4 mm flame is obtained. [. . . ] Never use abrasives, corrosive detergents, bleach or acids to clean the appliance. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]