User manual HOOVER HVH 5511

[. . . ] If they drop onto the hob, they may cause damage. ⷠDo not use the hob as a working surface. ⷠDo not use the hob for storage of any items. Immediately disconnect the hob from the electrical power supply and call the After Sales Service. [. . . ] However, do not let these pots boil dry. The following examples are for information only. Personal experience should then let you adapt these settings to your taste and habits. Melting heat 3 : Keeping hot 4 : Heating up 5 : Thawing, stewing, full cooking, low temperature cooking 6 : Cooking without lid 7 : Frying, meat browning and roasting 8 : High temperature cooking and roasting, seizing 9 : Frying, boiling large quantities of water. Now the zone goes off, the indicator goes off after 10 seconds. - To stop rapidly , press the and buttons at the same time. The heat level automatically goes down to . GENERAL STOP The cooking zones and the timer can be stopped at any moment by pressing for 3 seconds on the On-Off button. ⷠRESIDUAL HEAT INDICATOR The control panel tells the user when the surface temperature of the cooking zones exceeds about 60°C, by the following displaying: . When the temperature goes back below 60°C, the display goes off. For ending the cooking, we advise switching off the cooking zone and using the residual heat of the zone to finish cooking gently. After a cut in the current, the residual heat indicator disappears completely, even if the surface temperature exceeds 60°C. In the next 10 seconds - Press the button for the zone with the addition. TO STOP THE ADDITIONAL ZONE: - The cooking zone with addition must be live: in the display zone, the lamp must be on. The heat level automatically goes down to . Only one zone, at a time, can be programmed. - Start the required zone by following the previous instructions. The control LED near the heat level must be displayed, it shows that the zone is live. The zone mark around the timer display shows the controlled zone. - Press the button to select the time in minutes. This is saved automatically after three seconds. The programmed time can be modified at any moment by pressing the timer selection button, the timer control LED must be on. [. . . ] The on-off cycles vary according to the required heat level: - low level: short operating time, - high level: long operating time. A technician should verify the fitting in compliance with the recommendations, page 2. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]