User manual HOOVER HWE 413AMBS/1-S

[. . . ] We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials. [. . . ] The appliance calculates the time to the end of the selected programme based upon a standard loading, during the cycle, the appliance corrects the time to that applicable to the size and composition of the load. pROGRAMME END When the display shows that the programme is finished and the DOOR LOCKED indicator light has gone out, the door can be opened. Close the door BEFORE selecting the button START/PAUSE. To start the selected cycle with the preset parameters, press START/PAUSE. When the programme is running, the display will show the time to elapse. At the end of the cycle, switch off the appliance by turning the selector to OFF. The programme selector must be returned to the OFF position at the end of each cycle or when starting a subsequent wash cycle prior to the next programme being selected and started. Keep the START/PAUSE button pressed for about 2 seconds (some light indicators and the residual time display will flash, showing that the machine is paused). To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. For safety reasons, in some wash cycle phases, the door can be opened only if the level of the water is below its lower edge and if the temperature is less than 45°C. If these conditions are met, wait for the DOOR LOCKED light to switch off before opening the door. Press the START/PAUSE button again to re-start the programme from the point it had been paused at. cANCELLING THE SET PROGRAMME To cancel the programme, set the selector to the OFF position. Wait until the DOOR LOCKED light has gone out before opening the door. tEMPERATURE SELECTION button This button allows you to change the temperature of the wash cycles. It is not possible to raise the temperature over the maximum allowed for the programme, in order to protect the fabrics. To reactivate the spin cycle press the button until you reach the spin speed you would like to set. It is possible to modify the spin speed without pausing the machine. an over dosing of detergent can cause excessive foaming. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the program and increase water consumption. The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the noise and vibration in the machine and so prolongs the life of your machine. [. . . ] This may be due to a leak from the seal between the tap, supply hose and fill valve; in this case, replace it and tighten the hose connections correctly. Make sure the front filter is correctly closed. The machine is fitted with a detection system that protects the load and product from damage if the load is not balanced before spinning. this may result in:· The machine attempts to balance the load, increasing the time of The spin cycle aborting to protect the machine and load. [. . . ]