User manual HOOVER HWPD 610AMBC/1-S

[. . . ] We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials. [. . . ] When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected. Once the programme has started you will be kept informed constantly of the time remaining to the end of the wash. The appliance calculates the time to the end of the selected programme based upon a standard loading, during the cycle, the appliance corrects the time to that applicable to the size and composition of the load. Press the START/PAUSE button again to re-start the programme from the point it had been paused at. CANCELLING THE SET PROGRAMME To cancel the programme, set the selector to the OFF position. Wait until the DOOR LOCKED light has gone out before opening the door. tEMPERATURE SELECTION button This button allows you to change the temperature of the wash cycles. When the display shows that the programme is finished and the DOOR LOCKED indicator light has gone out, the door can be opened. At the end of the cycle, switch off the appliance by turning the selector to OFF. It is not possible to raise the temperature over the maximum allowed for the programme, in order to protect the fabrics. If you want carry out a cold wash all the indicators must be off. The programme selector must be returned to the OFF position at the end of each cycle or when starting a subsequent wash cycle prior to the next programme being selected and started. By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. If the label does not indicate specific information, it is possible to use the maximum spin expected in the program. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. To reactivate the spin cycle press the button until you reach the spin speed you would like to set. It is possible to modify the spin speed without pausing the machine. an over dosing of detergent can cause excessive foaming. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the program and increase water consumption. It is possible to cancel the delay start by turning the programme selector to OFF. If there is a break in the power supply whilst the machine is operating, when the power is restored, the machine will restart from the beginning of the phase it was in when the power was lost. The option buttons should be selected before pressing the START/PAUSE button. [. . . ] This may be due to a leak from the seal between the tap, supply hose and fill valve; in this case, replace it and tighten the hose connections correctly. Make sure the front filter is correctly closed. The machine is fitted with a detection system that protects the load and product from damage if the load is not balanced before spinning. this may result in:· The machine attempts to balance the load, increasing the time of The spin cycle aborting to protect the machine and load. [. . . ]