User manual HOOVER HZ16

[. . . ] Ensure the cleaner is positioned up against the bottom step. 7 www. hoover. co. uk 6 Using your cleaner USING THE CLEANING TOOLS 8 Tools mode Press the stair cleaning release button and lift the handle from the cleaner body. 8 There are 3 cleaning tools included: 9 Zoom Cleaning Tool with integrated crevice tool The Zoom Cleaning Tool can be extended for extra reach by pushing the collar and the handle away from each other. To retract the Zoom Cleaning Tool pull the collar towards the handle. 10 Furniture nozzle The furniture nozzle is stored on the cleaner body and fits on the crevice tool. [. . . ] Allow to air dry thoroughly before refitting. REMEMBER ­ To maintain optimum cleaning performance it is imperative to wash the HEPA pre-motor filter and foam pre-motor filter every 5 dust container empties. 14d 14e 15a 15b 16a 16b 16c www. hoover. co. uk 8 Maintaining performance CLEARING BLOCKAGES REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. 17 17 Clearing a blockage in the flexible hose Twist the hose end connectors to remove hose from both the base of the cleaner and the handle. Use a blunt rod to remove any obstruction. After clearing any blockage in the hose, refit both hose connectors ensuring the hose supports are located on the inner side of the hose. 18 Clearing a blockage at the cleaner base Remove the flexible hose as previously described. Unclip the cover at the base of the machine (18a). Check the lower hose for any blockages (18b). The lower hose can be easily removed for inspection. Refit hose and hose cover. 18a 18b www. hoover. co. uk 9 Maintaining performance 19 CHECKING BELT AND BRUSHES/ REPLACING THE BELT REMEMBER ­ Always switch off and unplug the machine from the electricity supply before checking the brushes, belt or removing the hood. 19a i) Remove the flexible hose from the cleaner ­ twist hose end connectors to remove hose at both ends as shown in section 17. Using a crosshead screwdriver remove 4 hood screws as shown (19a). Turn cleaner over and lift off hood (19b). Remove agitator brush and belt assembly by pulling upwards out of the cleaner base (19c). Replace belt, if worn or broken, by looping the new belt over the metal motor spindle (19d). Refit agitator brush assembly by holding the brush and stretching the belt. Align and insert both agitator end caps into slots in the base as shown (19e). When located, rotate the agitator brush to ensure free movement of the belt. [. . . ] The British Electrotechnical Approvals Board (BEAB), the independent UK national authority for the safety of domestic electrical appliances, ensure that European Safety Standards are met and maintained throughout the production life of an appliance. All appliances which pass these tests are permitted to carry the BEAB mark of safety. The Environment - WEEE Directive This appliance is marked according to the European directive 2002/96/EC on the Waste of Electrical and Electronic Equipment (WEEE). [. . . ]