User manual HOOVER IMPULSE CORDLESS POWER MOP

[. . . ] This cleaner was inspected and packaged carefully before being shipped from the factory. If you should happen to need assistance during assembly or operation: Visit us online at hoover. Only) or Call 1-330-499-9499 to speak with a representative in our Consumer Response Center. Review this manual before operating cleaner. [. . . ] Cap must be locked in place for proper performance and to prevent leaking. The recovery tank holds dirty cleaning solution that is picked up from the floor surface. An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing. When the recovery tank is full, the automatic shut-off activates, and the cleaner will not pick up dirty solution and the sound of the motor will change. To remove tank, press down on release button (A) and pivot tank forward. The filter screen may also be cleaned by rinsing it under running water. the tank lid contains a washable , reusable filter. Clean this filter when suction is low or reduced. Dry or loose debris will also collect on the filter screen (D) in the tank lid. To replace lid, align tab (E) on lid with hole on front of tank (F). To replace tank, insert bottom of tank into cleaner and pivot top portion until it is locked in place. Remove loose debris from filter by either brushing or tapping the filter. the filter may also be rinsed for additional cleaning. Fill solution tank with HOOVER® Floor-to-FloorTM Cleaner and water, according to instructions for Figs. Do not use pine or solvent based cleaning concentrates in your cleaner. Do not use any type of wax in your cleaner. Slowly move cleaner forward and backward over area (approx. After area is cleaned, move the mode selector switch to PICK UP. The agitator brushes are OFF and the mop's suction will pick up the dirty solution. Move cleaner over the area to pick up the dirty solution. To continue cleaning another area, move mode selector switch to SCRUB. NOTE: To extend battery charge, it is recommended that a small area (2' x 3') be cleaned completely in SCRUB mode, then switch to PICKUP mode. [. . . ] Align middle section (D) of nozzle with opening on cleaner (E). While holding nozzle in place, slide latches inward to lock in place. Extra care must be taken when cleaning the agitator brushes. CAUTION: Any other servicing should be performed by an authorized Hoover Service Representative. [. . . ]