User manual HOOVER NEXTRA

[. . . ] Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Blanking plug Inlet hose & hooked end support (see Unpacking and Installation Instructions) Base panel & x2 push clips Energy Label Your local council will be able to give you details of current means of disposal. [. . . ] The programme may be paused at any time during the wash cycle by holding down the button for about two seconds. when the machine is in the paused mode , the time remaining for the programme in the CHRONOVISION indicator and option buttons will flash. The indicator light will remain illuminated for approximately 2 minutes. The door can be opened when this indicator goes out. The indicator light is illuminated when the door is fully closed and the machine is ON. When is pressed on the machine with the door closed the indicator will flash momentarily and then illuminate. if the door is not closed the indicator will continue to flash. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the light has gone out before opening the door. As a safety measure, check that there is no water evident in the drum. Fast Iron Function Programme is completed by a short, very low spin speed. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine will then pump out the remaining water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the button and the machine will pump out the water and complete the cycle with a short spin cycle. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Press the button and the machine will pump out the water to complete the cycle. The clothes load will not be spun and will therefore be very wet. [. . . ] Are there any loose items in the pockets of clothing that can rattle in the drum and cause damage?Some programmes do take a long time (over 2 hours). Low water pressure can increase the length of the programme. If not wait a further couple of minutes and the light will go out and you will be able to open the door. [. . . ]