User manual HOOVER PRO STAIR

[. . . ] DO NOT use your cleaner out of doors or on any wet surface or for wet pick up. Keep hands, feet, loose clothing and hair away from rotating brushes. DO NOT pick up hard or sharp objects, matches, cigarette ends or other similar items. DO NOT pick up flammable liquids such as cleaning fluids, petrol etc. [. . . ] It extends to minimise stretching and bending. All accessories can fit on the end of the flexible hose. Always attach the hose retainer to the hose hook when using the cleaning tools. Unhook after use. Operation Lift the device upwards to the position shown in the diagram. Simultaneously squeeze the finger tabs and extend the device. CLEANING THE STAIRS It is dangerous to place the cleaner above you whilst cleaning the stairs. Ensure it is positioned up against the bottom step. DO NOT attach hose retainer when cleaning the stairs. * Features vary according to model When cleaning treads & risers use the crevice tool in the open position. When using the Pro Stair Brush keep the base of the nozzle flat to the carpet. Use Place the cleaner against the stairs and the Pro Stair Lock in the position shown. Use the stair cleaning hose and accessories as usual. To return the cleaner to carpet mode repeat the above process in reverse. -- 5 -5 29/11/2007 16:23:39 0565-5296. indd 5 EMPTYING THE DUST CASSETTE IMPORTANT: DO NOT FILL ABOVE THE INDICATED MAX LEVEL MARK SHOWN ON THE CASSETTE . Press down on door release pad and remove door. Remove the dust cassette from the cleaner using the handle grip on the front. Rotate the BLUE filter pack to the unlock position to release from the dust cassette. Turn the dust container and remove the BLUEtransparent shroud including the RED vortex finder. ! Empty the dust container of Repeat all steps in reverse dirt and debris. to refit the dust container on the product. Make sure that the RED and BLUE components are refitted. IMPORTANT: For optimum cleaning performance, always keep your filters clean. Hoover recommends to wash Pro Stair cassette filters after 5 container empties. -60565-5296. indd 6 29/11/2007 16:23:39 CLEANING THE FILTERS* Washing filter and foam: Rotate the BLUE filter pack until the unlock position to release it from the dust container. Washing pre-motor and exhaust filter: The pre-motor filter should be washed every three months. The Carbon filter is normally maintenance free, this component should not be washed. If a replacement is required please contact our spares department. Separate the GREY foam filter from the BLUE filter pack using the tab provided. The exhaust filter should be washed every month. Press down on the latch to remove the exhaust cover and filter. Wash the GREY foam filter thoroughly. DO NOT USE HOT WATER OR DETERGENTS! Gently tap to release excess dust. Wash the filter with the BLUE housing from the inside. DO NOT USE HOT WATER OR DETERGENTS! Remove excess water by shaking and leave to dry for 24 hours. [. . . ] To clean the filters, see the instructions on page 7. To set the carpet care control selector, see the instructions on page 4. To check the brushes, see the instructions on page 8. If so, it will take about 30 minutes to reset itself. [. . . ]