User manual HOOVER PURE POWER ALLERGY CARE TPP2321

[. . . ] HOOVER SERVICE: To ensure the continued safe and efficient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised Hoover service engineer. Getting to know your cleaner Main Cleaner On/Off Button Cord Rewind Button Suction Control Bag Check Indicator Bag Door Release Button Bag Door Handle Telescopic Tube Telescopic Tube Release Hose Carpet and Floor nozzle Carpet Care Control Selector 3 in 1 Tool Parquet Caresse Nozzle Pet Hair Remover Mini Turbo Brush Allergen Remover Turbo Brush Assembling your Cleaner Remove all components from the packaging. Connect the hose to the cleaner main body, ensuring it clips and locks into position. To release: simply press the two buttons on the hose end and pull [2]. [. . . ] To extend the brushes push the button on the body of the tool. parquet Caresse Nozzle*– For parquet floors and other delicate floors [1O]. Pet Hair Remover Mini Turbo Brush* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas [1P]. Allergen Remover Turbo Brush* – Use the turbo nozzle for deep cleaning on carpets. [1Q] Remember: The bag check indicator may also flash if an obstruction has occurred. In this case refer to ‘Removing A Blockage From the System’. Cleaning the Filter Hepa filter To maintain optimum performance of your cleaner, please wash the Pre-Motor filter after each 5 bag changes. To remove the Pre-Motor filter press the latch at the top of the Hepa pre-motor filter frame to unlock it from the cleaner . Tilt then remove the filter from the cleaner. Wash it in hand warm water, and allow it to dry thoroughly before replacing to the cleaner [16]. remember: Do not use hot water or detergents. In the unlikely event of the filters becoming damaged, fit a Genuine Hoover replacement. Do not try and use the product without a dust bag or filter fitted. Check if there is any other blockage in the system - Use a rod or a pole to remove any blockage from the Teletube or flexible hose. Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of time with the bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator turn green once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset. IMPORTANT: Do not use the mini turbo nozzles on rugs with long fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating. User Checklist Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. [. . . ] Trykk på pedalen på munnstykket [7] for å velge den ideelle rengjøringsmodusen for din gulvtype. Hardt gulv: Børstene er senket for å beskytte gulvet Teppe: Med løftede børster for dypest rengjøring 4. Trekk ut støpselet og trykk knappen for tilbaketrekking av ledning for å trekke ledningen tilbake inn i rengjøringsmaskinen [10]. [13] Trykk knappen [14] for å åpne dekselet og trekk i posens krage for å fjerne posen. [. . . ]