User manual HOOVER RBC040 ROBO.COM3

[. . . ] Please ensure the voltage marked on the mains power adapter is suitable for connection to standard mains power outlet voltage. rEMINDERS: •  Always store the appliance indoors. Do not use outdoors or expose the appliance to the elements, humidity or heating sources (oven, fireplace, wet floor). Com² or accessories to excessive heat / cold (Keep between 0-30°C). [. . . ] NOTE: The battery power usage relates directly to the infra red level. For longer battery life chose the correct length of infra red beam. NOTE: The near Infra red transmitter will stop the Robo. Com² coming any closer than 50cm to the Virtual Barrier*. Press the on / off switch on the side of the Robo. NOTE: If your robot is already switched On, but in standby mode, it can be activated from the remote control** or pressing one of the touch sensitive keys. NOTE: The touch sensitive controls on the Robo. Com² can be unreliable if your hands are wet. Using the Remote Control** press the time set button. A flashing line will appear below the day. Use the up and down arrow on the Remote Control** until the line appears below the correct day. Y NOTE: The cleaning hour will be the same each day scheduled for cleaning. CM MY S E CY Additional Features Automatic Return to the Charger Base Station: Press the Sensitive touch control on the robot or press the button on the remote control, this will activate the Automatic Return to the Charger Base Station NS CO I T I V E TO U N T ROL S C H CMY K UV Lamp*: Press the UV button on the remote control** to activate the UV lamp* for more hygienic cleaning. The UV indicator will light on in the LCD display. To deactivate the UV lamp*, just repress the UV button on the remote control**. Floor Polisher Pad*: Attached via the Floor Polisher Pad Holder * to the underside of the cleaner, the Floor Polisher Pad* is used to polish marble, parquet, wooden and other delicate NOTE: Do not use on a carpeted Surface. COM² CLEANER Before performing any maintenance task, ensure the Robo. Com² off and remove from the Charger Base Station. Use a damp cloth with a little soap to clean all surfaces. DO NOT allow water into any part of the product whilst cleaning. Emptying the dust container Empty the dust container every cleaning cycle or when the dust container is full. Com² off and remove from the Charger Base Station. [. . . ] €  Contact your local Hoover representative Cleaning power is weak The Remote Control** does not work The Robo. com² does not automatically charge The Robo. Com² is very noisy while cleaning Robo. Com² is not working but there is no error code display Error Codes The following codes may appear during use or on start up. [. . . ]