User manual HOOVER S4472

[. . . ] This plug is fitted with a 13-amp fuse (UK only). Hose connection: Open the cover; fit the hose connector and push until the locking tabs are in position, then make sure it is well locked (Fig. To disconnect the hose push the locking tabs on either side of the connector and pull the hose from the appliance. The accessories are simply pushed together and the locking clip rotated to the closed position. [. . . ] IMPORTANT: The wires in the mains lead are coloured in accordance with the following code: BLUE ­ Neutral BROWN ­ Live GREEN/YELLOW ­ Earth REMEMBER: After use, switch the product off and remove the plug from the electricity supply. Always switch off and remove the plug before cleaning the appliance or attempting any maintenance. 1 PRODUCT Safety cap Integrated handle Wheel Door Latch Monobloc Water tank cover On/off button Boiler Water shortage indicator Steam ready indicator Water heating indicator Steam regulation valve Fig. 2 ACCESSORIES Extension tubes Funnel Steam jet nozzle Extension for steam jet + round brush Bristle insert Carpet insert Multi use nozzle with rubber insert Flexible tube + handle Scrub insert Sponge insert Brass insert Window squeegee Your product has been designed to provide highest comfort during steam cleaning. The DRY function allows easy and efficient removal of condensed steam and loosen dirt without manual scrubbing with cloths. IMPORTANT: This product has not been designed to pick up dirt - so it does not replace the vacuum cleaner function. sTEAM CLEANING · Press the mains on/off button, this should illuminate green (Fig. The water-heating indicator will light during the heating phase, before steam is generated (Fig. The steam ready indicator will light when steam is available and the water-heating indicator will switch off (Fig. To release steam, first press from left to right the steam emission lock (Fig. Steam quantity can be selected through the steam regulation knob on the control panel (Fig. Remove the filter, rinse under warm water and dry completely before replacing (Fig. These are available from your local Hoover dealer or direct from Hoover. When ordering parts, please always quote your model number. HOOVER SERVICE Should you require service at any time please call your local Hoover service office. 2G) Use this tool over large surfaces using the following inserts: · How to fit inserts: (Fig. 17) Slide the two locks on the top of the nozzle to the open position. Remove the current attachment and insert the alternative with the large section to the front of the nozzle. Lock the attachments in position by sliding the locking features on the top of the nozzle to the locked position. crevice tool with angled steam nozzle (Fig. 2C) Ideal to clean difficult to reach areas, it may be used also to: · Clean taps, sinks and other sanitary fixtures etc. Steaming houseplants keeping min 50 cm safety distance. [. . . ] Steaming houseplants keeping min 50 cm safety distance. 2D), to remove stubborn dirt from small surfaces such as hobs, shutters, rugs between tiles, sanitary fittings and so on. The unit does not operate Boiler is not switched on Ensure the boiler is switched on and the button is lit Unit does not steam but dry mode still operational Wait for the steam ready light to illuminate Water tank is full Dry function is poor Hose may be blocked Empty water tank Attempt to dislodge if visable, if not seek professional assistance The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. [. . . ]