User manual HOOVER SC 142

[. . . ] Run over the supply cord whilst using the cleaner or remove the plug by pulling on the cord. Stand on or wrap the power cord around arms or legs when using the cleaner. Remove the cyclonic cassette before removing the hose from the cleaner. Use the appliance to clean people or animals. [. . . ] To release: simply press the two buttons on the hose end and pull (P1). Fit the hose/handle and floor nozzle onto opposite ends of the telescopic tube (P2 & P3). The accessory tools can be stored on the tool holder fixed to the telescopic tube (P3). uSING YOUR CLEANER Power supply - Pull cord and plug into power supply (P4). Please make sure the cord is fully extended before using the cleaner. press the on/off pedal once to start the cleaner (P5). Press it again to stop the cleaner before removing the plug after use. Press the cord rewind button to wind the power cord back into the cleaner (P6). Fixed power control (depending on model) - Adjust the suction by moving the handle valve: suction will decrease when opening the valve (P7). Variable power control (depending on model) - Slide the variable power adjuster to increase or decrease the suction (P8). Telescopic Tritube ­ The telescipic Tritube can be extended or collapsed by pressing the latches forward and pulling or pushing the tubes to the desired length (P9). IMPORTANT: Cleaning the washable filters - To maintain optimum performance please tap and, if necessary, wash the cyclonic cassette hepa filter and exhaust filter after 5 cassette empties using handwarm water. Remove excess water from the filters with a dry cloth and leave to dry fully before replacing. Do not try and use the product without the cassette or filters fitted. Unlatch then unhinge the filter panel from the bottom of the cyclonic cassette (21). Press the release latch on the blue filter frame to unlock the hepa filter from the filter panel (P22). Check if there is any other blockage in the system - Use a rod or pole to remove any blockage from the extension tube or flexible hose. Warning -The cassette check indicator will remain illuminated if the cleaner is used when the cassette is full, if there is a blockage or if the filters are dirty. If used for a period of over ten minutes with the cassette check indicator illuminated, an electronic cut out will switch the cleaner off to prevent any risk of overheating. If this should happen, switch the cleaner off, unplug and correct the fault (see ' Removing a blockage from the system'). The cut out will automatically reset upon switching the cleaner back on. USER CHECKLIST Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. [. . . ] Is there a working electricity supply to the cleaner?These are available from your local Hoover Dealer or you can buy original Hoover consumable spares online at www. UK or call 01204 556111: Cyclonic Cassette Hepa Filter: T90 - pack number 35600636 Purefilt Exhaust Filter: T87 - pack number 35600541 Mini Turbo Nozzle: J26 - pack number 35600543 Flexible Hose: D95 - pack number 35600544 C&F Nozzle: G85- pack number 35600545 Caresse Nozzle: G81-pack number 35600391 Should you require service at any time, please call your local Hoover Service office. the Environment This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical Electronic Equipment (WEEE). [. . . ]