User manual HOOVER SELF PROPELLED WINDTUNNEL BAGLESS

[. . . ] This product was designed for easy Assembly (See page 3) Review this manual before operating cleaner The model and serial number are located on the back of the handle as shown. For your personal records, please enter the COMPLETE model and serial number in the spaces provided and retain this information. Your cleaner is model___________________________________ and has serial number___________________________________ It is suggested that you attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER product. [. . . ] Wands are used to give extra length to your hose. How to attach tool cover The tool cover is designed with a "break-away" feature which allows it to snap free if it is pushed open too far. to reattach , align hinges of cover with slots on sides of tool storage area. How to clean tools To clean the hose and the powered hand tool, wipe off dirt with a cloth dampened in a mild detergent. Cleaning tools may be washed in warm water with a detergent. Turn cleaner OFF before disconnecting and connecting hose. Align end of extra reach hose with projections (M) over slots (N) on end of attached hose. Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. When to empty It is recommended that the dirt cup be emptied before the dirt reaches the dirt inlet opening on back of dirt cup (Fig. cAUTION: Very fine materials , such as face powder , cornstarch or fireplace soot , may seal the filter and cause loss of suction. When using the cleaner for this type of dust, empty the cup and clean the filters often. A B Slide hose into slots and twist hose to lock it into place. The dirt cup assembly consists of the following parts: Lid (A) Dirt Cup (B) Pre-filter (C) HEPA Cartridge Filter(D) Dirt Inlet Opening (E) While the cleaner is in operation, the prefilter screen will stop larger debris from entering the HEPA cartridge filter chamber. This larger debris will be seen collecting in the left side of the dirt cup. How to empty disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place. Lift cup slightly and pull straight out to remove from cleaner. To remove loose dirt from the HEPA filter, turn knob (G) on top of dirt cup lid at least one complete turn. Press down on area indicated (H) to open dirt cup lid. Note: It is not necessary to remove the HEPA cartridge filter to empty the dirt cup. Note: If dirt cup lid does not close completely, turn knob on lid until lid closes. Bottom of cup will rest behind grooves at bottom of cleaner cavity (I). [. . . ] Warning - Brush roll can start suddenly. Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages continuing with each step until the blockage is found: Turn cleaner OFF and disconnect from electrical outlet. Check fullness of dirt cup and filter assembly; empty cup and clean filters if needed. [. . . ]