User manual HOOVER SM4000C4 JAZZ VOITURE

[. . . ] Qxp 03/08/2006 16:10 Page 1 ENGLISH Please read these instructions thoroughly This product must be assembled and should only be used for it's intended purpose as described in these instructions. Safety reminders DO NOT pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items. DO NOT use the appliance if it appears to be faulty, or either the cord to the wall bracket or charger is damaged. DO NOT replace the battery pack with non rechargeable batteries. [. . . ] WEEE This appliance is marked according to the European directive 2002/96/EC on the Waste of Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Guarantee Statement During year 1 HOOVER engineers will replace or repair all defective parts free of charge, except for parts subject to fair wear and tear such as belts, brushes and bags. To qualify for benefits under guarantee, you must be able to provide proof of purchase and the appliance must have been supplied, maintained and used in accordance with HOOVER instructions. exclusions Consequential losses and accidental damage to the product. Any faults which occur due to incorrect installation or misuse. Repair or interference with the appliance by any person not authorised by Hoover. For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom. tO WALL MOUNT (Tools required: Screwdriver and drill) 1. Place the charging base against the mounting surface. Reposition base and insert screws, tighten screws and ensure base is fixed firmly to the wall. Charging Place the cleaner into the base, ensuring the shroud covers the back of the product. Note: Use only the charger supplied with your cleaner to recharge the unit. IMPORTANT: Before first use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be off. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use, let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in temperatures above 37°C or below 0°C How to use Remove cleaner from storage base, press the on/off switch once to turn on and again to turn off. [. . . ] The dust cup will be released from the main body of the product [picture 7]. Hold the dust cup over a waste bin and use the filter handle to remove the filter/deflector from the dust cup [picture 8]. Empty the dust container and brush the dust and dirt off the filters [picture 9]. The container, deflector (Wet & Dry only) and filters may be washed in warm soapy water. [. . . ]