User manual HOOVER ST 125

[. . . ] Run over the supply cord when using your cleaner or remove the plug by pulling on the supply cord. Stand on or wrap the power cord around arms or legs when using the cleaner. Use the appliance to clean people or animals. To avoid a safety hazard, an authorised Hoover service engineer must replace the supply cord. [. . . ] Do not pull the cord beyond the red marker. [2] Adjust the telescopic tube to the desired height by holding the handle and moving the central hand grip up or down. [3] Select carpet care control height by pressing the pedal in the nozzle. [4] Hard Floor ­ Brushes are lowered to protect the floor. [6] Switch off at the end of use by pressing the On/Off Button. Unplug and press the cord rewind button to wind the power cord back into the cleaner. When the dust reaches the max level indicator in the container empty the dust container. IMPORTANT:To maintain optimum performance do not allow the dust to sit higher than the max level. Release the container carry handle by lifting the centre latch to detach the dust container from the main cleaner and pull upward to remove. [8, 9] Hold the dust container over a bin with one hand and with the other pull the dust container catch to open the door and empty. [10] Close the dust container door and refit to the cleaner main body. Remove dust container from the cleaner by releasing the container carry handle to detach the dust container from the main cleaner and pull upward to remove. [8 , 9] Place the bin on a flat surface and unclip the clips from either side of the dust container. [16] Using the bin handle lift the bin upper section containing the cyclonic unit from the lower section. To lock in place push the container carry handle down until the latch connects with the main body of the cleaner. Once correctly retained the carry handle will sits flush with the top of the cleaner. Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. When ordering parts always quote your model number. Should you require service at any time, please contact your local Hoover Service Office. Check if there is any other blockage in the system - Use a rod or pole to remove any blockage from the extension tube or flexible hose. Check if pre-motor filter is fitted and filter door is closed Check if the cyclonic unit needs to be cleaned. [. . . ] quality BSI ISO 9001 Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001 Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. Is there a working electricity supply to the cleaner?The Environment: This appliance is marked according to the European Directive 2002/96/EC on waste Electrical and Electronic Equipment (WEEE). [. . . ]