User manual HOOVER STEAMAWAY

[. . . ] â· Do not point tools toward people or pets. Do not use any type of wax with cleaner. â· Keep detergents and other cleaners out of children's reach. â· Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. [. . . ] Use a crevice tool to reach into tufts and folds. Do not use the SteamVacTM cleaner as a dry vacuum cleaner. For upholstery, check cleaning code - Use your HOOVER SteamVacTM cleaner only if the upholstery fabric is marked with a "W" (for "wet" clean) or "S/W" (for "solvent/dry" or "wet" clean). Do not clean fabric marked "S" ("solvent/dry" clean only). If your upholstery does not have a code, seek professional assistance. Test for colorfastness - Wet a white absorbent cloth with the detergent. In a small, hidden area, gently rub the surface with the dampened cloth. Wait ten minutes and check for color removal or bleed with white paper towel or cloth. Choose the proper brush assembly for the cleaning task. The brush assembly with the green, shorter bristles is for carpets and rugs; the assembly with the white, longer bristles is for hard floor surfaces. Turn recovery tank latches (A) outward (one on each side of tank). Remove lint from filter screen located inside recovery tank. Remove lint from filter screen located on bottom of cleaner as follows. Note: When brushes seem to be rotating slowly, disconnect cleaner from electical outlet and check and clean this screen. Wipe off screen and push frame back into place. Vacuum thoroughly after carpet has completely dried. This will help reduce any shading left by the cleaner's brushes. If lint or other debris becomes lodged in nozzle, it can be removed for cleaning. With handle in upright position, tilt cleaner back so that handle rests on the floor. To replace nozzle, line up tabs (A) on nozzle with holes (B) in cleaner. The nozzle must be in the proper position in order for the recovery tank to go on properly. Raise cleaner to upright position and replace clean water tank (Fig. [. . . ] Make sure that the square post (C) also aligns with the square hole (D). Turn brushes slightly until post fits easily into hole. With handle in upright position, tilt cleaner back until handle rests on the floor. Empty recovery tank, rinse tank and lid thoroughly with clean water and let air dry. [. . . ]