User manual HOOVER STEAMVAC SPOTTER

[. . . ] Model number Serial number (Located on the data label on the back of the handle. When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE Review these instructions before operating cleaner Use only on surfaces moistened by the cleaning process or small spills. Do not clean over floor electrical outlets. Use cleaner only for its intended use as described in the instructions. [. . . ] To assure proper performance, it is recommended that only HOOVER detergent be used. Turn cap (H) upside down to serve as a measuring cup. In case of contact with eyes, flush with cold water for 15 minutes. In case of contact with skin, wash with water. Fill tank to fill line (J) (1 gallon ) with hot tap water. If rubber ring (K) on cap has displaced, replace it with uneven side against cap ledge (L) as shown. Cap must be locked in place for proper performance and to prevent leaking. The recovery tank holds the dirty solution that is picked up from the carpet. When the recovery tank is full, the automatic "shut-off" will engage (see page 5) and the tank must be emptied. How to empty Turn cleaner off and disconnect from electrical outlet. To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Position bottom of tank into unit and press on tank handle to snap tank into place. Step on handle release pedal (M) and lower handle until it rests on the floor. rotate recovery tank latches (N) outward (one on each side of tank). Lift tank off of cleaner and carry it to a sink or drain. Pour dirty water out from the rear of the tank (O). Position the front of lid under tabs (P) on front of tank. Make sure that the lid is secure on all sides before placing tank on cleaner. Rotate latches (N) (one on each side of tank) inward to lock tank in place. Raise handle to upright position and replace upper clean solution tank. Vacuum thoroughly - For carpet, use a vacuum cleaner with an agitator for best results. Do not use the `SteamVac' spotter/carpet cleaner as a dry vacuum cleaner. [. . . ] Refill tank according to instructions for surface being cleaned. Problem: Brushes/brush indicator won't rotate during floor cleaning Possible cause Possible solution · Remove clear cover over indicator and clean screen. Empty solution tank and rinse thoroughly with clean water. Replace empty solution tank and turn cleaner ON. [. . . ]