User manual HOOVER STEAMVAC TURBOPOWER

[. . . ] Review this manual before operating deep cleaner When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING APPLIANCE. Use only on surfaces moistened by the cleaning process or small spills. Do not clean over floor electrical outlets. Use extra care when cleaning on stairs. [. . . ] Empty tanks, rinse with clear water and let air dry. If lint or other debris becomes lodged in nozzle, do not attempt to remove nozzle cover. Pour one to two cups of clear water on a non-carpeted floor. Pick up water with your `SteamVac' deep cleaner. Repeat as necessary until debris is flushed out of nozzle. Read "Before you begin cleaning" instructions on page 9. Fill clean solution tank (upper tank) with HOOVER Carpet/Upholstery Detergent according to instructions on pages 7 and 8. Remove debris from recovery tank filter and rinse with clean water. Note: If the filter must be removed for cleaning, it is easier to replace if the filter is wet. If desired, vacuum thoroughly after carpet has completely dried. This will help reduce any shading left by the deep cleaner's brushes. Squeeze trigger to release cleaning solution and slowly push deep cleaner forward (equals one wet stroke). Continue to squeeze trigger and slowly pull deep cleaner back toward you (second wet stroke). Release trigger and slowly push deep cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull deep cleaner back toward you without squeezing trigger (dry stroke). Keep nozzle flat on floor for both forward and reverse strokes. For particularly soiled carpet or spots, use the Clean SurgeTM button (see following section). avoid saturating carpet , as noted below. Note: To avoid saturating carpet, do not use more than 4 wet strokes over one area. it is best to alternate wet and dry strokes as described above. For best cleaning results and to aid in faster drying of carpet, end with more dry strokes. (Continue using dry strokes until little water is visible passing through the recovery tank lid. [. . . ] ) · Empty recovery tank and rinse thoroughly with clean water. Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface. Do not store deep cleaner with a full solution tank In place. If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below. [. . . ]