User manual HOOVER SX 6254

[. . . ] When using the vacuum cleaner on stairs, always ensure that you hold the appliance steady with one hand. ⷠDo not leave the appliance unattended whilst it is switched on and ensure that children do not play around with the appliance. ⷠAlways pull out the plug ­ if the appliance malfunctions during operation ­ before cleaning and maintenance ­ after use ­ when changing the filter. ⷠNever unplug the appliance by pulling at the cable, but only by removing the plug directly from the socket. [. . . ] Lift the tube and flexible hose out of the liquid first and then turn off the appliance afterwards, in order to prevent an afterflow of liquid. a Open the snap-on fasteners and lift the motor block. Remove the filters from the appliance, because they will otherwise be damaged (figures C and D). if the cleaning fluid tank is fitted , remove it (figure H). Place the motor block onto the collecting bin and snap shut with snap-on fasteners. Remove the hose by turning the hose connecting piece to the side and withdrawing the hose. Close the suction power control (11) on the handle. After completion of wet vacuuming, please clean and dry the appliance and the accessories used. If this is the case, switch off the appliance and empty the collecting bin. Thereafter, in order to prevent excess foam, put 1 /2 cup of vinegar into the collecting bin. Excess foaming will not occur after you have thoroughly cleaned the carpet once with HOOVER cleaning concentrate, because it contains a special anti-foam substance. Ensure that there is always liquid in the fresh water container when the spraying function is switched on, in order to avoid possible damage to the pump. Remove the lid of the cleaning fluid tank and fill the tank with HOOVER Cleantex Cleaning Fluid. Take the suction hose for cleaning fluid out of its holder on the motor block. Place the motor block onto the collecting bin such that the suction hose (36) is immersed all the way to the bottom of the cleaning fluid tank and is not bent. Remove the hose by turning the hose connecting piece to the side and withdrawing the hose. insert the cut-off valve into its receptacle on the suction tube. Snap the handle into the suction tube and fasten the cleaning fluid hose to the flexible hose by means of the plastic clips. Snap the cleaning fluid hose into the quick coupling on the motor block. Fit the carpet spray extraction nozzle onto the suction tube. [. . . ] No cleaning fluid is coming out: - Is the pump switched on (switch (7) has to light up)?If the spray nozzle becomes clogged, lay the nozzle into water for a while and then blow strongly through it. To obtain approved HOOVER service and genuine HOOVER parts, please call: Gias Customer Service 08705400600 or your nearest Hoover Service Centre. Ensure that all service and repairs are carried out by an authorised Hoover Service Engineer. [. . . ]