User manual HOOVER TC1192

[. . . ] Reminder: while assembling or changing accessories during use stop the steam function by pressing from left to right the steam emission control. Please add 1 measured fill of Hoover Ecobreeze to the clean water, as described in the cleaner maintenance section. Hydrofilt is a water filter, specifically designed for an efficient wet & dry suction, which uses the natural purifying property of water. It is in fact the flow of water into the container that efficiently captures the dirt avoiding its dispersion into the environment. [. . . ] CLEANER MAINTENANCE: Emptying the Hydrofilt container Suction is stopped automatically by the safety float once the water level in the filter container has reached the MAX mark. This is also noticed by a distinctive change in the noise of the product and lack of suction. To empty the container please: Switch off the appliance with the ON/OFF main switch and unplug the power cable. Remove the Hydrofilit container from the appliance, holding it by the handle (Fig. 7) and empty the dirty water and refill to continue cleaning. Reassemble the filter cage and put it back inside the appliance. Note: Make sure that the Hydrofilt inlet is correctly positioned, checking that the arrow on the nozzle is aligned with the notch on the bottom of the cage (Fig. If the filter needs replacing, always use an original Hoover filter. Sanitizing the Hydrofilt container Hoover recommends the use of Hoover Ecobreeze to sanitize the Hydrofilt container while using the suction function. Directions of use: Shake the bottle and remove the safety cap. Hold the bottle upright and press until the dispenser is full to the recommended amount. Wait for a few minutes to allow the generator tank to cool down. To refill the boiler, simply refer to the preparations for use section to re-fill. WARNING: When filling the water boiler when it is already hot, we strongly advise you to SLOWLY AND CAREFULLY add just a little water at a time to avoid steam blowback from the aperture. ACCESSORIES: Steam and Vacuum use Floor brush (D) Use this tool over large surfaces using the following inserts: Bristled inserts (D1): suggested for hard floors dry vacuuming. Squeegee inserts (D2): designed for hard floors liquid suction therefore suggested with steam cleaning. carpet inserts (D3): suggested for carpets and moquette steam and vacuuming. How to fit inserts: Simply rotate the catch on the side of the nozzle clockwise to gain access to the inserts. When fitting the two bristled inserts (D1), position the grooved insert towards the front of the brush. When fitting the squeegee inserts (D2), ensure that both smooth surfaces face inwards. Crevice tool with angled steam nozzle (E) Ideal to steam clean and vacuum difficult to reach areas, it may also be used to: Treat stains on carpets Clean corners, window frames etc. Clean taps, sinks and other sanitary fixtures etc; Cleaning shutters, venetian blinds, radiators, car interiors etc Steaming houseplants. [. . . ] Clean the filter and remove any obstruction from the tubes and accessories. Switch off the appliance and allow it to cool. Disconnect the appliance from the mains for a few minutes and then try again. Switch the appliance off, empty the tank and restart cleaning. [. . . ]