User manual HOOVER TCP2010

[. . . ] ASSEMBLING YOUR CLEANER HOOVER SERVICE: To ensure the continued safe and efficient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised Hoover service engineer. Connect the hose to the cleaner main body, ensuring it clips and locks into position. To release: simply press the two buttons on the hose end and pull [2]. Connect the tube upper end to the handle. [. . . ] Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust bag should be disposed of correctly and carefully. Fold a new bag as shown on the bag and fit by inserting the collar into the bag holder. Refit the bag holder and close the bag door. Warning - The bag door will NOT close if the dust bag and/or the bag holder are not assembled to the cleaner. Always ensure the bag and bag holder are present when closing the bag door. Check if there is any other blockage in the system - Use a rod or a pole to remove any blockage from the Teletube or flexible hose. Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of time with the bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator turn green once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset. remember: The bag check indicator may also be red if an obstruction has occurred. In this case refer to ‘Removing A Blockage From the System’. Cleaning the Filters To maintain optimum performance of your cleaner, please wash the filters after each 5 bag changes. ACCESSORIES AND NOZZLES All accessories can be fitted to the end of the handle or the end of the tube. [23] 2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice tool. By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored neatly at the rear of the cleaner. To extend the brushes push the button on the body of the tool. Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas [1T]. Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas. [. . . ] If so, it will take approximately 30 minutes to automatically reset IMPORTANT INFORMATION Your Guarantee Hoover spares and Consumables Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. When ordering parts always quote your model number. H64, 35600637 H63, 35600536 U63, 35601193 G130, 35601195 G131 PC, 35601196 J54, 35601197 J46, 35601116 D128, 35601194 The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. [. . . ]