User manual HOOVER TFS 5204

[. . . ] Please supervise the use of the appliance by older children, the elderly or the infirm. IT IS IMPORTANT THAT YOU DO NOT: • • • • • • • • • Position the cleaner above you when cleaning the stairs. Use the cleaner out of doors on wet surfaces or for wet pickup. Pick up matches, hot ash, cigarette ends, hard or sharp objects or anything that may damage the cleaner. [. . . ] Press the pedal again to lift the brush head when cleaning carpets. Mini Turbo Nozzle (depending on model) - Use the mini turbo nozzle (P11) for deep cleaning on textile surfaces. Important: do not use the Mini Turbo Nozzle on rugs with long fringes, animal hide and with carpet piles deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating. Multifunction Tool - (P12) This tool can be used as: 1. Crevice tool: for corners and hard to reach areas 2. Qxp 13/03/2007 12:23 Page 3 GB Parking and storage - The telescopic tube can be parked for temporary storage during cleaning or in the storage position when not in use (P13 & P14). CLEANER MAINTENANCE: Replacing the dust bag (depending on model) - If the bag check indicator is illuminated (P15) please check and, if necessary, replace the dust bag. Pull the bag collar to remove the dust bag (P18) and carefully dispose of the bag into a bin. Fit a new bag into the cleaner by inserting the bag collar into the bag holder. Important: The hose must be removed before removing or replacing the dust bag. remember: The bag check indicator will also illuminate if an obstruction has occurred. In this case refer to the section "Removing a blockage from the system". Emptying the permanent dust bag (depending on model) - If the bag check indicator is illuminated (P15) please check and if necessary, empty the permanent dust bag. Pull the bag collar to remove the dust bag (P18) from the cleaner. Remove the plastic guide at the end of the bag allowing dirt collected to fall into the bin (P19). Return the guide back into the original position. Replace the permanent dust bag by inserting the bag collar into the bag holder. Check the filters for excessive build up of dust and if necessary clean the washable filter (see 'Cleaning the washable filters’). Removing the pre-motor and exhaust filters To remove the pre-motor filter (HEPA or Purefilt, depending on model): 1. Open the bag door and remove the dust bag from the cleaner (see 'Replacing the dust bag’). Press the latch at the top of the pre-motor filter frame to unlock it from the cleaner. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or shop where you purchased the product. Guarantee The guarantee conditions for this appliance are as defined by our representative in the country in which it was sold. [. . . ]