User manual HOOVER THE ONE

[. . . ] To benefit fully from the advanced features of The One, please ensure you read this User Guide carefully. " In the unlikely event of you finding a part missing, or if you have any concerns regarding this product, DO NOT TAKE THE PRODUCT BACK TO THE RETAILER. Please call the Hoover Advice Helpline (Open 7 days a week) on Before assembling, please check and identify the following components as you unpack the cleaner: · 1 Stand The One on the floor and push the handle firmly into the top of the cleaner making sure it clicks into place. 2 Place the dust container onto the ribbed moulding and push into main body until it clicks into place. [. . . ] 7 Positioning the cleaner for maximum safety Your cleaner incorporates an `Anti tip' design. Ensure the cleaner is positioned up against the bottom step. 8 Tools mode Press the stair cleaning release button and lift the handle from the cleaner body. There are 3 cleaning tools included: 9 Zoom Cleaning Tool with integrated crevice tool The Zoom Cleaning Tool can be extended for extra reach by pushing the collar and the handle away from each other (9a). To retract the Zoom Cleaning Tool pull the collar towards the handle (9b). REMEMBER - Make sure handle is fully clicked into place after use. Filling must not exceed the maximum level indicated on the dust level viewing window. REMEMBER ­ Always switch off and unplug the machine from the electricity supply before maintaining your cleaner. 12 Dust container release Holding the pre-motor filter cover, press the dust container release button and lift the dust container from the cleaner. 13 Dust container emptying The 2-stage opening system minimises the escape of dust when emptying. To release fine dust first, firmly hold the dust container and push down the hand grip at the back of the container with your palm (13a). After clearing any blockage in the hose, refit both hose connectors ensuring the hose supports are located on the inner side of the hose. Check the lower hose for any blockages (18b). The lower hose can be easily removed for inspection. Switch the cleaner off and remove the power cord from the socket. Look underneath the foot and remove the blockage. Once the brush rotates freely the cleaner can be used again. Reinsert the plug into the socket and turn the cleaner on. Please be aware the cleaner will automatically return to its last setting when switched on. NOTE: It will take about 10 minutes for the safety device to automatically reset. User Checklist If your cleaner has stopped working completely, run through the following Checklist: i) Is there a working electricity supply to the cleaner?A thermal cut out switches off the cleaner automatically to prevent overheating if the cleaner is used when the dust container is over full, or the filters require cleaning, or there is a blockage. [. . . ] The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ]