User manual HOOVER TW 1750

[. . . ] IMPORTANT: The wires in the power cord are coloured in accordance with the following code: Blue - Neutral Brown - Live 13 Amp fused plug on UK versions only. GETTING STARTED By following this step-by-step guide your new Hoover cleaner will be ready for use: Remove cleaner and accessories from packaging. [. . . ] The tubes can be stored into the storage slot underneath of the cleaner. Lift the bag holder vertically out of the cleaner and remove the Bag from its holder (13). Fold and fit new bag into the bag holder (13). Remove the plastic slide at the end of the bag allowing dirt collected to fall into the bin Refit the slide back into its original position. Fit the empty Permanent bag into the bag holder (13). To maintain best performance we recommend you wash the filters and the Permanent bag (depending on model) after 5 full bags. FILTERS AND PERMANENT BAG MAINTENANCE To maintain best performance we recommend that you rinse the filters and permanent bag under lukewarm water after 5 full bags To access the filters please refer to diagrams 2 & 3 Do not scrub the filters and permanent bag and do not use detergents Remove excess water with a dry cloth and leave to air dry until fully dry After completing the washing operations, return the filters and permanent bag to their original positions in the cleaner. 2) If not full then: a) Did you wash the filters and permanent bag after 5 full bags? if not please refer to chapter "FILTERS AND PERMANENT BAG MAINTENANCE". B) Check if there is any other blockage in the system. Use a rod or pole to remove any blockage from the tubes and flexible hose. it may also be possible to remove an obstruction in the flexible hose by lightly squeezing or bending it. [. . . ] To avoid safety hazards the cleaner must only be repaired by an authorised Hoover Service Engineer. H58 Guarantee Statement The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. [. . . ]