User manual HOOVER UH70400

[. . . ] Please enter the complete model and manufacturing code in the spaces provided. CODE Hint: Attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER® product. Be sure to register your product online at Hoover. [. . . ] 2 To remove hose for tool use, press the hose release button and pull hose end out. To lock back into place, push hose into hose tube until you hear a click. Press handle wand release button and pull handle up to remove. Press the hose release button on the nozzle and remove the hose from the nozzle. For extended cleaning reach, you may attach the hose to the stair hose*. Choose the 3-in-1 combination tool or use the extension wand alone. 5 The hose and tools can be used for stair cleaning. To avoid personal injury or damage, and to prevent the cleaner from falling, always place cleaner at bottom of stairs on floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage. Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure continued cleaning effectiveness. Any other servicing should be done by an authorized service representative. 2 Empty the dirt cup before the dirt cup reaches the max line (A). To reduce the risk of injury from moving parts, unplug vacuum before servicing. Do not use vacuum without dirt cup or filters in place. Very fine materials, such as face powder or cornstarch, may seal the filter and cause a reduction in performance. When using the vacuum for this type of dust, empty the cup and clean the filters often. 2 Press dirt cup release button and pivot cup out. 3 Hold dirt cup over trash receptacle, push dirt cup door release lever (A) to open dirt cup door (B). 4 Place bottom of dirt cup into vacuum body first. Press down on the dirt cup release button to secure into place. To maintain optimal performance, filters should be cleaned every two months under normal use. To reduce the risk of injury from moving parts, unplug vacuum before servicing. [. . . ] 20 Place the bottom plate aligning the screw holes and install the 6 screws as shown. Belt: what to buy Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt, ask for Belt - HOOVER® part No. If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. [. . . ]