User manual HOOVER WA 110

[. . . ] Remove the machine from its packaging close to the final location of the machine. Cut carefully around the base of the packaging and up one corner. Make sure it is out of the reach of children, it is a potential source of danger. If damaged do not use and please call GIAS Service. [. . . ] The inlet and outlets should be kept free from obstructions. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. There should be a gap of at least 12mm between the machine and any obstructions. Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet. Before using the tumble dryer for the first time: Please read this instruction book thoroughly. Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Do not overload the drum, large items when wet can exceed the maximum admissible clothes load (for example: sleeping bags, duvets). Check that all fastenings are closed and that pockets are empty. Place clothes loosely in the drum to make sure that they don't get tangled. By care symbols These can be found on the collar or inside seam: Suitable for tumble drying. However, we recommend that the container is emptied after each drying cycle. NOTE: Very little water will collect during the first few cycles of a new machine as an internal reservoir is filled first. Gently pull the bottom of the kickplate so that it unclips from the dryer. The top section can then be unhinged allowing the kickplate to be completely removed. Pull firmly on the handgrip and slide the water container out of the dryer. Support the container with both hands. When full, the water container will weigh about 4kg. Refit the kickplate by engaging the hinges at the top and 'snapping' the lower clips into place. Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. Turn the two locking levers anti-clockwise and pull out the condenser. Gently remove any dust or fluff with a cloth, then wash the unit by holding it under a running tap turning it so that water flows between the plates, to remove any dust or fluff. [. . . ] When the programme is complete the STOP indicator will light. The drum, door and load may be very hot. It is possible to change the programme within the first 10 minutes without using the cancel and reset function. Clean the filter and empty the water container after every drying cycle. [. . . ]