User manual HOOVER WINDTUNNEL BAGLESS

[. . . ] Self-Propelled TM WindTunnel Bagless with Powered Hand Tool by HOOVER This product was designed for easy Assembly (See page 3) www. hoover. com Owner's Manual ENGLISH § pp. 1-15 ESPAÑOL § pág. 16FRANÇAIS § p. Review this manual before operating cleaner Fill in and retain The model and serial number are located on the back of the handle as shown. For your personal records, please enter the COMPLETE model and serial number in the spaces provided and retain this information. Your cleaner is model___________________________________ and has serial number___________________________________ It is suggested that you attach your sales receipt to this owner's manual. [. . . ] Make sure the white side of the filter faces outward. Should you want to replace this filter, ask for part No. Do not operate cleaner without the filter in place. 3-14 O Check agitator shield Because your cleaner picks up so well, we strongly recommend you check for debris accumulation under the agitator shield each time you clean the filters. Removing debris under the shield will help maintain you cleaner's excellent pick up and suction. Remove debirs as follows: Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101. 3-15 Reattaching filter door The filter door is designed with a "break-away" feature which allows it to snap free if it is pushed open too far. To reattach, align hinges (O) of cover with slots on sides of filter area. Disconnect cleaner from electrical outlet. Check for dirt accumulation by removing bottom plate (Fig. 3-24), and lifting agitator shield (Fig. Remove any debris and replace shield, agitator and bottom plate (Figs. 4-2, 3-27 and 3-22). Removing lens Disconnect cleaner from electrical outlet. Using a screwdriver, remove the two screws as shown and lift off lens. 3-16 3-17 Installing bulb Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place Excessive force is not required. Replacing lens Reposition lens and secure with the two screws. Continued 9 Belt replacement The belts are located under the bottom plate of the cleaner and should be checked from time to time to be sure they are in good condition. The flat (wide) belt is described below; the other is described under "Brush roll replacement". To check the flat belt, remove bottom plate as shown in Fig. Replace belt if it is stretched, cut or broken. 3-18 What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for flat belt Hoover part No. 38528035. When to replace Disconnect cleaner from electrical outlet. Warning - Brush roll can start suddenly. Unplug cleaner when it is turned over. Replacing flat belt Disconnect cleaner from electrical outlet. Warning - Brush roll can start suddenly. Unplug cleaner when it is turned over. A Removing bottom plate Place handle in low position and turn cleaner over so bottom side is up. [. . . ] Remove screws on lower back of cleaner handle (A) and remove lower dirt duct (B). Clear blockage from dirt duct sections. 4-2 C Checking under bottom plate 4. Remove bottom plate, belt and agitator (see "The belt" section). Look into opening (C) for blockages and remove. [. . . ]