User manual HOOVER WINDTUNNEL BAGLESS CANISTER CLEANER

[. . . ] Review this manual before operating cleaner. The model and serial number are located on the bottom of the cleaner. For your personal records, please enter the COMPLETE model and serial number in the spaces provided and retain this information. Your cleaner is model________________________________________________________ and has serial number ______________________________________________________ It is suggested that you attach your sales receipt to this owner's manual. [. . . ] The power nozzle can be used for cleaning hard surface floors such as wood, linoleum, vinyl, asphalt and rubber tile, sealed cork, concrete and terrazzo, as well as carpet. To turn the brushes off for hard surface floor cleaning, press the FLOOR/CARPET (E) switch again. Note: The headlight will be OFF when in hard floor cleaning mode. Special edge groomers are provided on both sides of the nozzle to remove dirt in carpet near baseboards and furniture. Pull up on edge of lid in recessed area to open. A tool may be attached to either the hose or telescoping wand by pushing it firmly onto the hose end or the end of the wand. Select the tool best suited for the cleaning task from the following descriptions. Dusting brush/furniture nozzle this 2-in-1 tool may be used with the brushes in place (dusting brush) for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters and registers. Crevice tool may be used in tight spaces, corners, and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. Small brush is used for cleaning the dirt cup filter. How to clean stairs place cleaner on stair. Using the furniture nozzle, clean stairs from bottom to top. When to empty 3-1 How to empty Turn cleaner off and disconnect from electrical outlet. Press the button (B) on the top of the cleaner and pull the dirt cup straight out. The dirt cup needs emptying before the dirt reaches the "MAX" line (A) on the dirt cup or after every use if preferred. cAUTION: Very fine materials , such as face powder , cornstarch , fireplace ashes or fireplace soot , may seal the filter and cause loss of suction. When using the cleaner to remove this type of dust, empty the cup and clean the filters often. Should the dirt cup platform flaps (C) become dislodged, refit using the diagram on the platform. Clean the filter using the small brush located under the tool lid. If desired, the filter may be rinsed by running it under cold tap water. Shake excess water from filter and allow to dry thoroughly before replacing it in cleaner. replace the filter by lining up tabs on filter with grooves on lid and rotating clockwise. [. . . ] To check condition of brushes, move edge of a card across bottom plate while turning brush roll. An internal thermal protector has been used in your cleaner to prevent overheating if a large item or clog gets caught in the nozzle or at the opening of the bag. When the blockage is not removed, the thermal protector will trip and the cleaner will stop running. If this happens, turn cleaner OFF and disconnect cleaner from electrical outlet. [. . . ]