User manual HOOVER WINDTUNNEL SELF PROPELLED BREATHE EASY U6485200B

[. . . ] Please enter the complete model and Manufacturing Code in the spaces provided. CODE Hint: Attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER® product. Be sure to register your product online at Hoover. [. . . ] Before reaching edge, push down on handle. This will lift up the front of cleaner as shown and will prevent rug from clinging to cleaner. Continue to lift front of cleaner so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower front of cleaner, and use only forward strokes. 11 Special edge groomers are provided on both sides of the front of the cleaner to remove dirt in carpet near baseboards and furniture. To clean the hose, wipe off dirt with a cloth dampened in a mild detergent. Cleaning tools may be washed in warm water with a detergent. Actual model may vary from images shown. 12 When using cleaning tools, cleaner handle should be in the upright position to activate the automatic "brushroll OFF" and for convenience in moving the cleaner from one area to another. Turn cleaner OFF before disconnecting and connecting hose to hose tube (A). Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. Furniture nozzle may be used for upholstered furniture, draperies, mattresses, clothing, automobile interiors, and carpeted stairs. Crevice tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. Wands are used to give extra length to your hose. Powered hand tool may be used for upholstered furniture, carpeted stairs and hard-to-reach places. 14 Attach any tool or wand to the hose (G) by pushing it firmly into hose. Attach second wand or tool to wand (H) by pushing it firmly onto the wand. With handle in upright position, clean from bottom to top. To avoid personal injury or damage, and to prevent the cleaner from falling, always place cleaner at bottom of stairs or on floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage. Actual model may vary from images shown. Align end of extra reach hose with projections (I) over slots (J) in dirt duct. [. . . ] Remove any blockage from turbine channel (D). Replace belt turbine, brushroll, belt guard and bottom plate. Look into opening (F), in channnels (G) and around liner (H), and remove any accumulated debris. The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. [. . . ]